Installation - Window & Doorsets
General: Installer
Glazing
All glazing should conform with the BS6262 and BS 8000-7 documentation.
Support the glass units correctly in accordance with BS 6262 with glass support and packing
blocks.
Examine all glass units for damage prior to installation. Defective units should not be used.
Insulated glass units incorporating safety glass should be installed with the safety glass on the
appropriate side. (Note, the marking of the safety unit must remain visible after installation).
Insulated units with Low emissivity coating should be installed in conjunction with the
manufacturers instruction. Failure to do so may make the coating less effective.
Window/door packing configurations
Fixed window Side hung Top hung Bottom hung
Tilt/turn window Pivot window
Viewed Internally
Residential door French door
Note: All sashes should be See BS 6262 for further
packed at a maximum of window configurations and
75mm from the corners in styles.
order that the dead load
applied by the sealed units
weight is distributed correctly.
Issue: 2 (January 2008) 18
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36 |
Page 37 |
Page 38 |
Page 39 |
Page 40 |
Page 41 |
Page 42 |
Page 43 |
Page 44 |
Page 45 |
Page 46 |
Page 47 |
Page 48 |
Page 49 |
Page 50 |
Page 51 |
Page 52 |
Page 53 |
Page 54 |
Page 55 |
Page 56 |
Page 57 |
Page 58 |
Page 59 |
Page 60 |
Page 61 |
Page 62 |
Page 63 |
Page 64 |
Page 65 |
Page 66 |
Page 67 |
Page 68 |
Page 69 |
Page 70