CRACK IN CARGO HOLD COVER LEADS TO WET DAMAGE DESCRIBED IN LATEST SWEDISH CLUB BULLETIN
In its monthly safety scenario, April edition, the Swedish Club describes a case of cargo damage caused by water ingress due to a crack in the hatch coaming. The incident resulted in several days of delay for the ship to get the wet cargo off the vessel, while most of the cargo was refused by the buyer.
The bulk carrier had a full cargo of zinc concentrate onboard and was sailing from the west coast to the east coast of South America. When the vessel passed Cape Horn, it experienced heavy weather of Beaufort scale 9 with green sea covering the cargo hold covers 1, 2 and 3. This continued for 4 days as the vessel battled the waves. The vessel had no weather routing.
During discharge the surveyor found that the sounding pipes for the cargo bilges were blocked by debris. The sounding pipes should be clear of any debris or cargo, as they are important for taking soundings before loading and during the voyage.
Findings When the vessel was alongside, and the cargo hold hatches were removed, puddles could be seen in hold 1. It is important to be aware that zinc concentrate may liquefy if shipped with a moisture content in excess of their transportable moisture limit (TML) as per the IMSBC code. Puddles of water will obviously exceed the TML.
When the chief officer inspected the hatch coaming and cover for hold 1, a crack was found on the hatch coaming. The drain pipes for the non-return drain valves were full of debris and cargo. It should be a PMS job to check that the drain pipes and drain valves are not clogged and that the float (ball inside) moves freely.
Hatch covers, and coaming steel structures are heavily loaded elements. Their condition has a direct effect on the load carrying capacity and the safety of the vessel. The steel construction should always be inspected after an unusual loading case, and there should also be regular checks as per the PMS.
When repairs are carried out, only steel approved by the classification society should be used. High tensile steel is commonly used for cargo hatches and coamings. The classification society should be contacted before making any structural steel repairs.
Lessons to be learned As a result from the incident, the Swedish Club provided 15 questions to consider in order to prevent similar incidents in the future:
– What were the immediate causes of this accident? – Is there a risk that this kind of accident could happen on our vessel? – How could this accident have been prevented? – What are our procedures for inspecting cargo hatch covers? – How do we ensure cargo hatch covers are weathertight? – Do we use weather routing? – Do we record all maintenance in the PMS? – How often do we inspect the hatch coamings? – How often do we inspect the drain lines and valves? – How often do we inspect the sounding pipes? – What sections of our SMS or PMS would have been breached if any? – Does our SMS or PMS address these risks? – How could we improve our SMS and PMS to address these issues? – What do you think was the root cause of this accident? – Is there any kind of training that we should do that addresses these issues?
Read dozens of other categorised safety briefings and reports on the IIMS web site at
https://bit.ly/2V4QgtP
20 | The Report • June 2019 • Issue 88
Safety Briefings
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36 |
Page 37 |
Page 38 |
Page 39 |
Page 40 |
Page 41 |
Page 42 |
Page 43 |
Page 44 |
Page 45 |
Page 46 |
Page 47 |
Page 48 |
Page 49 |
Page 50 |
Page 51 |
Page 52 |
Page 53 |
Page 54 |
Page 55 |
Page 56 |
Page 57 |
Page 58 |
Page 59 |
Page 60 |
Page 61 |
Page 62 |
Page 63 |
Page 64 |
Page 65 |
Page 66 |
Page 67 |
Page 68 |
Page 69 |
Page 70 |
Page 71 |
Page 72 |
Page 73 |
Page 74 |
Page 75 |
Page 76 |
Page 77 |
Page 78 |
Page 79 |
Page 80 |
Page 81 |
Page 82 |
Page 83 |
Page 84
