PROJECT 12


16: DO THE TWIST Grasp both wires about 1cm away from the bead. Hold the wires slightly apart otherwise when you twist, it will twist down the full length. Holding tightly on to the two separated wires with one hand, grasp the bead in your other hand and twist (this is called a Tiara Twist). Carefully repeat the twisting until the 1cm is evenly twisted. Be careful not to over twist as this will snap the wire.


16 17 17: ...AND TWIST 18


18: WRAPPING Continue binding the two circles together by doing one wrap over both circles (to give you the two and two continuation). Then carry on wrapping two wraps around the inner circle, two wraps around both circles.


When you reach the bottom of the next arm, continue around the rest of the snowfl ake as explained earlier.


46


AGAIN Once you have twisted approximately 1cm, follow the same procedure but only leave a gap of approximately 1cm after the bend holding the crystal. Again, grasp tightly at the intersection with the main stem and repeat the Tiara Twist until you reach the main stem. Next, twist the main stem until you have approximately 1cm of the stem still untwisted. Then add a further crystal using the same technique. Continue twisting the main stem until you reach the base of the circle. Repeat this on the other side of the stem with another crystal.


Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32  |  Page 33  |  Page 34  |  Page 35  |  Page 36  |  Page 37  |  Page 38  |  Page 39  |  Page 40  |  Page 41  |  Page 42  |  Page 43  |  Page 44  |  Page 45  |  Page 46  |  Page 47  |  Page 48