search.noResults

search.searching

dataCollection.invalidEmail
note.createNoteMessage

search.noResults

search.searching

orderForm.title

orderForm.productCode
orderForm.description
orderForm.quantity
orderForm.itemPrice
orderForm.price
orderForm.totalPrice
orderForm.deliveryDetails.billingAddress
orderForm.deliveryDetails.deliveryAddress
orderForm.noItems
CABOCHON RING WITH PATTERNED BAND | INTERMEDIATE 12 13


13: ALTERNATIVE


SETTING If you do not have the Technique Master Bezel Set, you can use an alternative method. First, lightly sand the top of the bezel to make sure it is even, then place the ring into a ring clamp and put the stone into the bezel. Make sure the bezel is not too high for the stone – if it is, take the stone out and fi le the bezel until it is the right height for the stone.


Once you are happy with the fi t of the stone, start to set the stone by gently pushing the bezel with a bezel pusher around the stone, working on opposite sides until all the edges are pushed against the stone.


12: SETTING THE


CABOCHON To set the stone using the Technique Master Bezel Set (which I have used), place the ring into a ring clamp, and put the stone into the bezel cup.


Choose a punch that is slightly bigger than your bezel, and start hammering in a circular motion (without the handle) until the bezel is closer to the stone. You may need to change your punch to a slightly smaller one at this point, to bring the bezel in further again and secure the stone.


When you are happy with the setting of the stone, burnish the outside of the ring by putting the punch in the handle and push against the ring in a circular motion again. Then burnish the inside of the bezel with a burnisher, to give it a nice fi nish and to secure the stone further.


Make sure the stone is secure and doesn’t move, if it does go around the bezel pushing it against the stone again. When the stone is secure, you can then burnish the edge of the stone by pushing it around the bezel, making the stone more secure and with a beautiful fi nish.


14: FINISHING


TOUCHES To fi nish off , clean up any marks on the bezel from setting it by sanding them away, carefully and give the ring a fi nal polish. Finish.


27


Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32  |  Page 33  |  Page 34  |  Page 35  |  Page 36  |  Page 37  |  Page 38  |  Page 39  |  Page 40  |  Page 41  |  Page 42  |  Page 43  |  Page 44  |  Page 45  |  Page 46  |  Page 47  |  Page 48