PROJECT 5


4: CREATE THE


SHAPE With the straight wires parallel, grip in the bail making pliers and form a loop large enough to accommodate the clasp on the end of the necklet.


Once the fi rst coils have been made, work on each side individually. Wrap a further two times around the bail making pliers. Remove from pliers and repeat on the other side. This should give you a three coil wrap on each side of the Bunny’s ear.


Trim the excess wire, making a neat cut at the back of the pendant. File the ends smooth with an emery stick if required.


5: THREAD THE


PEARL Thread the Swarovski® pearl onto the 0.4mm wire and wrap three times onto one side of the bottom of the Bunny.


Using the other end of the wire, wrap three times around the other side of the Bunny’s bottom.


Feed the free end of the wire carefully back through the drill hole of the pearl and bring out on the other side BELOW the previous three wraps.


Continue wrapping now to fi ll in the gap on the bottom curve of the Bunny’s bottom. This will help anchor the pearl in place as well as looking good.


5 18


4


Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32  |  Page 33  |  Page 34  |  Page 35  |  Page 36  |  Page 37  |  Page 38  |  Page 39  |  Page 40  |  Page 41  |  Page 42  |  Page 43  |  Page 44  |  Page 45  |  Page 46  |  Page 47  |  Page 48