CHAPTER 8
ANCHORING As in docking, preparation is the key to successful anchoring. Before anchoring, take down and stow the jib. Make sure the foredeck is clear except for the anchor and its line (rode), which should be coiled on the deck (laid out in large loops) so it will run freely. If there is a pulpit, make sure the anchor and rode will run under it.
WIND
The Danforth anchor is very common. It is strong, lightweight, holds well, and is easy to store.
1When everything is prepared, sail on a reach, about 3-6 boat lengths downwind of where you want to drop your anchor. When you are directly downwind of where you want to drop it, head up into the wind.
2As the boat comes to a stop, lower (do not throw or drop) the anchor. After it hits the bottom, pay out the anchor line as you drift back.
TIP
In ideal conditions you minimally want: E3 feet of rode for every foot of depth for a swim
E5 feet of rode for every foot of depth for a picnic
E7 feet of rode for every foot of depth if the boat will be left unattended or you are staying for an extended period
44 Table of Contents
CWhen you’ve reached the spot where you want the boat to remain, firmly cleat off the rode. Check for adequate scope and that your anchor is holding. Then lower your mainsail.
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36 |
Page 37 |
Page 38 |
Page 39 |
Page 40 |
Page 41 |
Page 42 |
Page 43 |
Page 44 |
Page 45 |
Page 46 |
Page 47 |
Page 48 |
Page 49 |
Page 50 |
Page 51 |
Page 52 |
Page 53 |
Page 54 |
Page 55 |
Page 56 |
Page 57 |
Page 58 |
Page 59 |
Page 60 |
Page 61 |
Page 62 |
Page 63 |
Page 64 |
Page 65
