This content requires Adobe Flash Player version
or later.
Either you do not have Adobe Flash Player installed,
or your version is too old,
or there is a problem with your Flash installation and we were unable to detect it.
Step 4: Fold the sides up and continue to follow the weave pattern.
5
Step 5: Fold the loose pieces over and weave the bottom of the box. Loosely tie the ribbon to make sure it doesn’t slip out.
Step 6: Cut the end pieces short and weave it back into the pattern.
7
Step 7: The ribbon ends are now at the bottom of the ring box where all the end pieces are woven in. Tape the guide ribbon to you decorative ribbon and pull it through to the opposite side.
6
8
Step 8: Do the same with the other ribbon end.
Step 9: Tie the ribbon and decorate the box with succulents, twigs, beads and add the wedding rings.