HEALTH & SAFETY
M
anaging health and safety in the oil and gas industry has always been a complex challenge. But economic pressures have created
additional hurdles that need to be overcome. Te industry has been through a particularly challenging period since the beginning of the oil price downturn in 2014. However, the multitude of risks present on sites, including the presence of combustible toxic atmospheres and machine hazards, still need to be managed as companies now have to meet health and safety requirements on tighter budgets. We have seen an influx of new innovations into the sector with drones and mobile- operated technology becoming part of daily operations. In the new era of caution in the industry, could technological innovation be the solution?
WHAT ARE THE CHALLENGES IN 2017? Incidents on oil and gas sites have the potential to escalate quickly. Te Health & Safety Executive’s (HSE) UKCS Gas release data notes that 3,272 gas release incidents were reported between 2000 and 2015 – 198 of which occurred while a site was in shutdown. 68, more than a quarter, resulted in an ignition incident. Te potential number of risks associated with these incidents is considerable and the responsibility for site safety lies with operators. Ensuring the safety of
The key to safer working
Allan Ralston discusses how technological innovation can unlock health & safety and operational benefits
employees is of paramount importance to operators, so many have had to look for new solutions.
Te HSE implemented the Fee for
Intervention (FFI) cost recovery regime in 2012. Te regulation allows for the HSE to recover costs for carrying out
inspections on sites that are found to be in material breach of health and safety laws. With an hourly rate of £129 and no cap with the amount billed being based on the hours spent on the investigation, unexpected costs can quickly become significant under the new legislation. Te additional cost and resources needed to address required health and safety regulations means it is becoming increasingly hard to meet regulatory requirements. Cost cutting can inadvertently cause individuals to cut corners and with many companies under greater financial strain, non-essential works have been delayed and in some cases, critical repair schedules have been pushed back. Finding the balance between operational efficiency and maintaining high health and safety standards has become an even greater challenge in recent years.
Habitats prevent sparks from hot work being dispersed
48
www.engineerlive.com
THE HOT TOPIC Hot works are particularly challenging, especially in zoned areas where the potential risks are much greater with
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36 |
Page 37 |
Page 38 |
Page 39 |
Page 40 |
Page 41 |
Page 42 |
Page 43 |
Page 44 |
Page 45 |
Page 46 |
Page 47 |
Page 48 |
Page 49 |
Page 50 |
Page 51 |
Page 52 |
Page 53 |
Page 54 |
Page 55 |
Page 56
