PRODUCTS & EQUIPMENT
MAC introduces improved ultrasonic weld line tester
M
agnetic Analysis Corp. has recently supplied a new Echomac® WLD
ultrasonic weld line test system for an Ohio tube mill. Featuring new operating conveniences for inspecting tube weld zones on-line during continuous production, the system is designed to test for longitudinally oriented defects that are typical of the ERW welding process. These systems are typically four channels, using both CW and CCW sound modes for detection of ID and OD longitudinal defects between 5% and 10% of wall thickness. Additional channels can be added, depending on the application. The WLD system includes
MAC’s well regarded Echomac® instrumentation, and a test head incorporating transducer assemblies with irrigated shoes for constant coupling with the tube being tested. A key issue in weld line inspection is keeping the transducers focused on the weld zone, despite changes in the weld location during production. Maintaining optimal positioning of the transducer assemblies with respect to the weld zone in the Echomac WLD is quick and easy with a new “joystick” that allows the operator to rotate the entire test head by means of a high resolution stepper motor. At any time, the operator can verify that the transducers are correctly positioned by observing a monitor which shows a laser beam that must bisect the weld center. With this convenient control, the transducer assemblies can be rotated to follow the weld to achieve continuous optimal testing over a weld position of 10:00 to 2:00 o’clock. Individual adjustment of each transducer to easily achieve optimal position for CW and CCW direction is available. In addition a coupling alarm alerts the operator to any loss of coupling between any transducer and the
18 IMT September 2016
Ultrasonic Weldline Tester with test head conducting production testing of a tube. A separate calibrate tube is shown in the off -line position in the foreground
tube, because of loss of water or improper alignment.
Another convenience during operation is that individual irrigated transducer shoes can be easily exchanged to accommodate tube size changes in 5 seconds using MAC’s new quick disconnect mechanisms. The test head is supported by
a strong gantry that allows for operating on the weld line for mill testing, or off line for easy calibration for a new tube size. A precision roller assembly is located in the off -line position to
allow for easy calibration of the transducers. Once the calibration is achieved, the test head is simply moved back to the on- line position for production line testing. A large, oversize stainless steel catch pan is used to help control splash water and keep the operator area relatively dry. The premium Allen Bradley system controls are designed for simple operation, but have fl exible features accessible in the fl at panel control display. Siemens Controls are also available, if requested. The remote operator
www.internationalmetaltube.com
station contains essential controls including the video monitor. The instrument system is programmed with the transducer locations and a spray marker located downstream is automatically instructed to spray paint onto the actual defect location to enable sorting of the cut tubes. Separate colors can be selected for OD and ID condition. Chart recordings are also generated that represent the tube condition of each cut tube. These are stored in digital format and are archived for future retrieval.
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36 |
Page 37 |
Page 38 |
Page 39 |
Page 40