EXPAND YOUR BUSINESS Fall Prevention Planning “An ounce of prevention is worth a pound of cure”
The phrase, “An ounce of prevention is worth a pound of cure,” has been repeated over and over again by millions of people with rarely a thought to its origin. It was written by none other than Benjamin Franklin and appeared in the Feb. 4, 1735 edition of the “Pennsylvania Gazette.” It is relevant here not just because of its obvious merit, but because Benjamin Franklin used it in making a sound case for a safety issue of his time. He was try- ing to convince people of the need for an orga- nized firefighting group in the greater Philadel- phia area. His point was well taken because by the end of the next year the city of Philadelphia had its first volunteer fire department called the Union Fire Company. Today, safety should be a primary concern
not just on a construction job site but in all work- place conditions. Why? According to Occupa- tions Safety and Health Administration (OSHA), falls are among the most common causes of serious work-related injuries and deaths. In most cases these accidents could have been prevent- ed. It was for this reason that the organization was established in 1971, and since then OSHA has continued to set and enforce workplace safety and health standards.
Slips, trips and falls Falling incidents are commonly referred to as slips, trips and falls (STFs). The U.S. Department of Labor recently published data showing that in just the year 2011, STFs accounted for 4,693 deaths or 14 percent of all workplace fatalities in the United States. Falls from elevation hazards are present at almost every job site, and many
workers are exposed to these hazards daily from rooftops, unguarded machinery or being struck by heavy construction equipment. Any walking/ working surface could be a potential fall hazard. Additionally, many industrial facilities have ma- chinery and equipment being used that require extreme care when operating or repairing on an ongoing basis. Fall prevention can include a variety of actions
to help reduce the risk of accidents. According to OSHA, an unprotected side or edge which is 6 feet or more above a lower level should be protected from falling by the use of a guard rail system, safety net system or personal fall arrest system. Fall arrest can be divided into two major types: personal fall arrest and general fall arrest.
Personal fall arrest system The personal fall arrest system or PFAS ("lifeline") must include four elements referred to as the AB- CDs of fall arrest: • A – Anchorage: a fi xed structure or structural adaptation, often including an anchorage connector, to which the other components of the PFAS are rigged.
• B - Body Wear: a full body harness worn by the worker.
• C - Connector: a subsystem component connecting the harness to the anchorage, such as a lanyard.
• D - Deceleration Device: a subsystem component designed to dissipate the forces associated with a fall arrest event. Each of these elements is critical to the
effectiveness of a personal fall arrest system. There are many different combinations of
products that are commonly used to assemble a personal fall arrest system, and each must meet strict standards. The specifi c environment or application generally dictates the combination or combinations that are most appropriate.
General fall arrest General fall arrest can include, but is not limited to, non-slip walkways, guard rails, caged ladders, stair railings and safety nets. While these are more permanent solutions, their presence at a workplace can truly prevent serious injury and death. Even before using any of these fall arrest
solutions, fall prevention starts with the right mindset. For a safe environment to exist, work- ers need to be properly trained and be focused on safety fi rst. Hands-on training in the recogni- tion, avoidance and prevention of construction safety hazards is offered by OSHA as well as other organizations. A continued awareness of safety by employ-
ees and employers both at the construction site and the workplace will go a long way to promote fall prevention and avoid serious injury or death. Or, as Benjamin Franklin once said, “an ounce of prevention is worth a pound of cure.”
James M. Fox is president of Fayetteville, Ga.-based Design Components Inc. For more information, visit
www.designcomponents.com or call (800) 868-9910.
By James M. Fox
Fall prevention can include a variety of actions to help reduce the risk of accidents. 36 METAL CONSTRUCTION NEWS December 2013
This safety harness and lanyard can be an effective tool in fall protection.
www.metalconstructionnews.com
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36 |
Page 37 |
Page 38 |
Page 39 |
Page 40 |
Page 41 |
Page 42 |
Page 43 |
Page 44 |
Page 45 |
Page 46 |
Page 47 |
Page 48 |
Page 49 |
Page 50 |
Page 51 |
Page 52 |
Page 53 |
Page 54 |
Page 55 |
Page 56 |
Page 57 |
Page 58 |
Page 59 |
Page 60 |
Page 61 |
Page 62 |
Page 63 |
Page 64 |
Page 65 |
Page 66 |
Page 67 |
Page 68