search.noResults

search.searching

dataCollection.invalidEmail
note.createNoteMessage

search.noResults

search.searching

orderForm.title

orderForm.productCode
orderForm.description
orderForm.quantity
orderForm.itemPrice
orderForm.price
orderForm.totalPrice
orderForm.deliveryDetails.billingAddress
orderForm.deliveryDetails.deliveryAddress
orderForm.noItems
Flow, level & control M


archwood Power operates a £380million natural gas-fired combined cycle (CCGT) power station on


Marchwood Industrial Park, adjacent to the River Test near Southampton. The station generates almost 900 MW of electricity for the national grid, enough to supply over one million homes. This is equivalent to the needs of Southampton, the New Forest and Winchester. The facility uses the latest technology to ensure maximum energy efficiency and minimal impact on the environment. It is currently one of the most efficient power stations in the UK. The “under-slung” condenser vessel sits


directly under the Steam Turbine in Marchwood Power station, condensing the exhausted steam and returning it to an aqueous state, which is then circulated for reuse in the generation cycle. A reliable, accurate level control is critical in this part of the process; if the vessel gets too high, it could impinge on the turbine itself causing untold damage and loss of generation. The correct condensate level needs to be maintained to ensure the condenser back pressure is at the optimum value, lowering the flash point of water and preventing wet steam from contacting the low pressure turbine blades, assisting steam flow through the turbine and increasing efficiency. When originally designed and commissioned, the plant installation consisted of three Differential Pressure transmitters, using a two out of three voting method and a single magnetic float gauge on a bypass chamber. However, there were ongoing issues with DP measurement, mainly due to the condensate filled impulse lines, and vacuum within the condenser, which meant they often had an unreliable level measurement on at least one, increasing the risk of nuisance trips. A DP based level system for this type of measurement is complex and requires a lot of interconnecting pipe work, valves, and condensate pots. There was much ongoing work undertaken with balancing the condensate in pots and the wet legs, as well as regular recalibration of the DP transmitters themselves. Marchwood Power’s requirement was three devices that would remain accurate in relation to each other and the process, enabling higher plant availability. VEGA recommended Marchwood opt for additional interconnecting pipe work where the magnetic level gauge is installed, so that they could fit three VEGAFLEX GWR transmitters into bypass tubes, using the same two out of three


Reliable turbine condenser level


In this article, Doug Anderson, VEGA Controls, explains how guided radar level transmitters improved reliability at a natural gas-fired combined cycle power station at Marchwood Power.


voting method, which would give them reliable accurate level measurement and control. VEGAFLEX use guided wave microwave pulses to detect the level, these are virtually unaffected by temperature, pressure, vacuum. There were no issues with the bypass tubes sharing the same vessel connection ‘manifold’, as it is a ‘clean’ process. The units were mounted to the side of the boiler, alongside the existing MLG, where there was plenty of head room for installation. The measuring range required was over 1.7 m and the temperatures were much lower than the process at 40ºC, (even though VEGAFLEX can go to 450ºC and 400 Bar if needed). Marchwood installed each GWR in a 50mm diameter bypass tube configuration, with isolation valves at the top and bottom. Once in place, it just needed the GWR units to be cabled and they


32


were ready to commission. Marchwood Power engineers carried out the setup themselves using PACTware software, so they could have a full configuration back up and calibration record. As well as reducing maintenance costs, the installation of the new sensors was a more reliable, simpler system and the cost was much lower than the original arrangement. Since installation, no outages due to unreliable


levels have been recorded; there is very good correlation and repeatability between devices, which makes the two out of three system work as it should. With no moving parts, and unaffected by density, pressure or vacuum changes, the VEGAFLEX GWR sensors have delivered the reliability that Marchwood Power were looking for.


VEGA Controls www.vega.com June 2020 Instrumentation Monthly


Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32  |  Page 33  |  Page 34  |  Page 35  |  Page 36  |  Page 37  |  Page 38  |  Page 39  |  Page 40  |  Page 41  |  Page 42  |  Page 43  |  Page 44  |  Page 45  |  Page 46  |  Page 47  |  Page 48  |  Page 49  |  Page 50  |  Page 51  |  Page 52  |  Page 53  |  Page 54  |  Page 55  |  Page 56  |  Page 57  |  Page 58  |  Page 59  |  Page 60  |  Page 61  |  Page 62  |  Page 63  |  Page 64  |  Page 65  |  Page 66  |  Page 67  |  Page 68  |  Page 69  |  Page 70  |  Page 71  |  Page 72  |  Page 73  |  Page 74