UNDERFLOOR HEATING
WHEN THE HEAT IS ON
Flooring installation over overlay heating systems – Kerakoll has it covered.
The stresses on a flooring installation caused by underfloor heating should not be under estimated and it is important to ensure that the correct installation methods are adhered to, especially when under time pressure. Kerakoll’s UFH systems are specifically designed to allow rapid and reliable installations that deliver long-lasting performance without compromising on quality.
Once the carrier board and pipework are installed, the whole surface should be primed and then Proflow Finish used to level and smooth the floor prior to the installation of floorcoverings.
Proflow Finish can easily cope with the expansion and shrinkage caused by underfloor heating. This single component self- smoothing compound is a true all rounder, moisture tolerant and suitable for use in any installation, on any substrate and with any type of resilient flooring at depths of up to 60mm. It has a free flowing formulation, a 30-minute wet edge time, and is able to accept foot traffic and floorcoverings after 3.5 hours. It has an EC1-Plus GEV Emicode rating.
Proflow Smooth is a good alternative where access to other parts of the site is needed more quickly as it accepts foot traffic after only 90 minutes and floorcoverings after just 3.5 hours. This self-smoothing compound has a unique free flowing formulation that fills and smooths any substrate imperfections and creates a flawless surface finish effortlessly. With working and wet edge
times of 30 minutes, it gives the best blend of extended working times and rapid installation.
Once the floor has been smoothed, Eco-3000 HT should be used to install the floorcovering. This is a high temperature universal adhesive is suitable for installing LVT, PVC, vinyl flooring as well as carpet and textiles onto a wide variety of substrates. It is ideal for use in conservatories, as well as other buildings with large expanses of glass where direct sunlight may heat the floor. Tilemaster Eco-3000 HT has been formulated with a fast tacking- off time. Flooring can be installed after as little as 10 minutes, when the adhesive is semi-tacked off and has reached its ‘anti- slide’ state.
˝Proflow Finish self-smoothing
compound is a true all rounder, moisture tolerant and suitable for use in any installation, on
any substrate and with any type of resilient flooring at depths of up to 60mm.˝
You can also contact your local Sales Representative, or the customer service team for more information on the system and products featured, to arrange a trial or answer any questions that you may have, using the contact details below.
Tel: 01772 456831
Email:
info@kerakoll.co.uk Website:
www.kerakoll.com
Image credit: © Envira Floors
36
www.tomorrowscontractfloors.co.uk
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36 |
Page 37 |
Page 38 |
Page 39 |
Page 40 |
Page 41 |
Page 42 |
Page 43 |
Page 44 |
Page 45 |
Page 46
