This content requires Adobe Flash Player version
or later.
Either you do not have Adobe Flash Player installed,
or your version is too old,
or there is a problem with your Flash installation and we were unable to detect it.
‡ Correct fit-up for these OREGON® bars required that a 6-digit part number be used in addition to the usual 10-digit part number. 188SLHK095 is designed for 3/8" – 64 DL • 39450 is for designed for 3/8" – 68 DL
Chain saws with a green triangle have a displacement of less than 62 cc (3.8 cu. in.). These saws must meet the low kickback requirements of the ANSI B175.1 standard. Chain types labeled green meet the low kickback provisions of the ANSI standard. Chain types labeled yellow have higher kickback potential and may not comply with low kickback provisions of the ANSI standard. See ANSI B175.1 standard, page FOR 7.
Part numbers printed in red italics have been obsoleted. Contact your authorized OREGON® distributor for availability.
Chain saws with a yellow triangle have a displacement greater than 62 cc (3.8 cu. in.) and may, but are not required to, comply with ANSI low kickback requirements. These saws should be operated by users with experience and specialized training for dealing with kickback and are not recommended for general consumer use. In many cases, a low kickback, green label saw chain can be applied to these saws but the kickback potential may still exceed that of the low kickback provisions of the ANSI standard. See ANSI B175.1 standard, page FOR 7.