This content requires Adobe Flash Player version
or later.
Either you do not have Adobe Flash Player installed,
or your version is too old,
or there is a problem with your Flash installation and we were unable to detect it.
Comments: • In a few cases, where two bars would have the same length in their part numbers but different drive link counts, the letter Z will be used in the bar-mount description to distinguish between them (K095 and Z095 for example).
• Chain saws originally equipped with an Intenz® bar, and saws adapted to take an Intenz® bar, do not have a “bar adjustment pin” for tensioning the chain. Use ONLY an Intenz® bar when replacing the guide bar on these saws. See page for 4 for important information on Intenz® bars.
• Power Match® solid body bars may be stamped with XXX, ZZZ or other letters as they can have different noses installed on the body, thereby changing the part number.
• Guard Mate® holes are built into the noses of certain types of OREGON® bars and allow the attachment of a Guard Mate tip guard to help reduce the risk of kickback.
• OREGON® Sculptor™ carving bar part numbers do not follow the OREGON® bar part numbering system.
Bar types and part numbers printed in red italics have been obsoleted. Contact your authorized OREGON® distributor for availability.