Reference Material - Cabling
3-pin Australian Mains Plug Use
Marking
Active A Neutral N Earth
E Active Neutral Earth Approvals, Permits and Compliance
ACA / Austel Compliance The Australian Telecommunications Authority (Austel) were responsible for issuing cabling licences, equipment permits and monitoring the conduct of licence and permit holders for all equipment and components connected to the Australian telephone network. The Spectrum Management Agency (SMA) was the Australian Commonwealth statuary agency responsible for the management of radio-communications in Australia. On 1 July 1997, AUSTEL and SMA merged to form the Australian Communications Authority (ACA). The ACA is now responsible for technical regulation, consumer issues and licensing of telecommunications and radio-communications in Australia.
A-Tick The A-tick and ACA supplier code indicates c o m p l i a n c e w i t h A u s t r a l i a n telecommunications requirement and that the equipment can be legally connected to the Australian Telecommunications Network. Our ACA supplier code is N692.
Electrical Safety Compliance & RCM Power cords and AC adaptors for use in Australia must be tested for compliance with state electrical safety authority regulations. The New South Wales state government department responsible for electrical safety is the Department of fair Trading (DOFT). Most other states also have a department responsible for issuing Electrical Safety Certificates. A safety certificate issued in any state is recogonised Australia wide. The product must be market with a valid Electrical Safety Certificate Number e.g. N13816 or a RCM number issued by Standards Australia (SAA) e.g. N5071. C-Tick markings may also appear on an AC adaptor and show compliance with EMC standards. The RCM (Regulatory Compliance Mark) may be used as an alternative to show compliance with Electrical Safety and EMC standards. Our RCM (SAA) number is N5071.
N5071 DTMF - Dual Tone Multi Frequency N692
C-Tick C-Tick markings may also appear on products which are required to comply with Australian electromagnetic compatibility requirements and radio-communications standards and indicate that the product may be legally sold in Australia. Our ACA supplier code is N692. Since 31 December 1998, all equipment which requires EMC compliance must be marked with the C-tick and ACA supplier code number. The supplier is responsible for holding a Compliance Folder which contains complaint test reports and a Declaration of Conformity.
N692
A-Cross I f a n i t e m c o v e r e d b y t h e Telecommunications Labeling Notice does not comply with the applicable standard(s) and it is not a permitted item, it is regarded as non-compliant. All non-compliant items must be labelled with the A-Cross non- compl iance symbol and the non- compliance notice shown below.
DTMF is the signaling method used for dialing by most modern telephone. A pair of frequencies is assigned to each of 12 dial buttons on the telephone. An additional column of DTMF signaling is also sometimes referred to as Tone Dialing, VF Signaling, MF Dialing or Touch Tone. The “#” symbol is also known by many different names including Crosshatch, Hatch, Pound and Octothorpe.
DTMF Frequency Matrix Hz
697 Hz 1 770 Hz 4 852 Hz 7 941 Hz *
Tip and Ring
1209 Hz 1336 Hz 1477 Hz 1633 2 5 8 0
High Group Frequencies 3
6 9 #
Tip Ring Sleeve
A B C D
Brown Blue
Green/Yellow
Flex Conductor Colors
Building Wire
Conductor Colors Red
Black Green/Yellow
CAUTION DO NOT USE BEFORE READING THE INSTRUCTIONS
Do not connect this customer equipment or customer cabling to a carrier or carriage service provider’s telecommunications network or facility unless:
(A) you have the written consent of the network or facility manager; or
(B) the connection is in accordance with a connection permit or connection rules.
Connection of this customer equipment or customer cabling may cause hazard or damage to the telecommunications network or facility, or persons, with consequential liability for substantial compensation.
The names for the two wires of a telephone line were derived from the electrical contacts on the original 1/4 inch telephone plug. These plugs are similar in appearance to the 6.5mm diameter stereo phono plugs that are sometimes still used for stereo handsets. One electrical contact is at the tip of the plug (used for Line +) and the other is a ring just above it (used for Line -). There is also a third contact referred to as the sleeve.
www.accesscomms.com.au 172 Sales and Support, Call: 1300 ADI ADI Technical Support, Call: 1800 220 345
www.adiglobal.com/au
Services
Low Group Frequencies
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36 |
Page 37 |
Page 38 |
Page 39 |
Page 40 |
Page 41 |
Page 42 |
Page 43 |
Page 44 |
Page 45 |
Page 46 |
Page 47 |
Page 48 |
Page 49 |
Page 50 |
Page 51 |
Page 52 |
Page 53 |
Page 54 |
Page 55 |
Page 56 |
Page 57 |
Page 58 |
Page 59 |
Page 60 |
Page 61 |
Page 62 |
Page 63 |
Page 64 |
Page 65 |
Page 66 |
Page 67 |
Page 68 |
Page 69 |
Page 70 |
Page 71 |
Page 72 |
Page 73 |
Page 74 |
Page 75 |
Page 76 |
Page 77 |
Page 78 |
Page 79 |
Page 80 |
Page 81 |
Page 82 |
Page 83 |
Page 84 |
Page 85 |
Page 86 |
Page 87 |
Page 88 |
Page 89 |
Page 90 |
Page 91 |
Page 92 |
Page 93 |
Page 94 |
Page 95 |
Page 96 |
Page 97 |
Page 98 |
Page 99 |
Page 100 |
Page 101 |
Page 102 |
Page 103 |
Page 104 |
Page 105 |
Page 106 |
Page 107 |
Page 108 |
Page 109 |
Page 110 |
Page 111 |
Page 112 |
Page 113 |
Page 114 |
Page 115 |
Page 116 |
Page 117 |
Page 118 |
Page 119 |
Page 120 |
Page 121 |
Page 122 |
Page 123 |
Page 124 |
Page 125 |
Page 126 |
Page 127 |
Page 128 |
Page 129 |
Page 130 |
Page 131 |
Page 132 |
Page 133 |
Page 134 |
Page 135 |
Page 136 |
Page 137 |
Page 138 |
Page 139 |
Page 140 |
Page 141 |
Page 142 |
Page 143 |
Page 144 |
Page 145 |
Page 146 |
Page 147 |
Page 148 |
Page 149 |
Page 150 |
Page 151 |
Page 152 |
Page 153 |
Page 154 |
Page 155 |
Page 156 |
Page 157 |
Page 158 |
Page 159 |
Page 160 |
Page 161 |
Page 162 |
Page 163 |
Page 164 |
Page 165 |
Page 166 |
Page 167 |
Page 168 |
Page 169 |
Page 170 |
Page 171 |
Page 172 |
Page 173 |
Page 174 |
Page 175 |
Page 176 |
Page 177 |
Page 178 |
Page 179 |
Page 180 |
Page 181 |
Page 182 |
Page 183 |
Page 184 |
Page 185 |
Page 186 |
Page 187 |
Page 188 |
Page 189 |
Page 190 |
Page 191 |
Page 192 |
Page 193 |
Page 194 |
Page 195 |
Page 196 |
Page 197 |
Page 198 |
Page 199 |
Page 200