Ok with our first skull placed in the front of the helmet on center around the helmet with two single lines that cross each other to
we can now add the barb wire. For this House of Kolor Orion Sil- represent one strand of barb wire. Add as many strands as you
ver or Auto Air Aluminum Base can be used, I use Orion Silver, think will look cool remembering the wire goes under the skull in
either way be sure to follow the manufactures tech sheets. I the front. Do not be overly concerned about over spray at this
have no photo reference for the barb wire and just render what point as we will take care of that shortly.
I imagine old barb wire might look like. I work my way all the way
Give the silver time to dry and apply a coat of inter coat clear wire as pictured, for the barbs use small pieces of fine line tape
such as House of Kolor SG100 along the barb wire you just and cut the end so it is pointed. To take care of that overspray
sprayed and allow the proper time to flash or dry. Now using use your base black and spray over the fine line tape you just
your favorite width of fine line tape cover up the strands of barb put down.
Now to add the basic outline for the rest of the skulls we’ll use detail. As you can see we are adding these skulls right over the
that same skull template. Starting at the first skull we’ll just go barb wire already in place.
around the helmet place skulls randomly keeping me mind some If you are not into skulls this same technique could be applied
will be behind others, it’s a pile of skulls after all. At this point you using just about any object flowers, piece signs your imagination
are just sort of sketching the skulls in do not be concerned with is the limit.
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32