Laboratory Drench Hoses and Eyewashes Drench Hose SE920
For the rapid flushing of spillages and splashes from the body. Comprises 3/8" NPTF self-closing valve activated by a squeeze handle. The valve head incorporates the aerated hose nozzle providing efficient “wetting” and improved water “cling” to contoured areas such as the eyes, nose, chin or cheeks. The valve/nozzle is connected to a 1.5m flexible reinforced PVC supply hose with valve hanger and 1/2" NPTM inlet connector. A nozzle dustcap is also supplied. Requires connection to a suitable water supply.
SB720-15 Drench hose SE920 Drench Hose SE921
Similar to SB720-15 but with an integral mounting flange which allows fixing to benchtops up to 37mm thick. The valve/nozzle is connected to a 1.8m flexible reinforced PVC supply hose with 1/2" NPTM inlet connector. In use the valve/nozzle is removed and the hose is drawn through the benchtop and flange. Requires connection to a suitable water supply.
SB720-25 Drench hose SE921
Drench Hose SE927 Similar to SB720-25 but with 3/8” NPTF stay-open ball valve and twin aerated hose nozzles. The valve/nozzle is connected to a 1.8m flexible reinforced PVC supply hose with 1/2" NPTF inlet connector. Requires connection to a suitable water supply.
SB720-30 Drench hose SE927 Safety Note:
Some chemical spillages must not be flushed or treated with water. Please refer to your safety officer or supervisor for advice on alternative procedures.
Eyewash SE505
Wall mounting with aerated single nozzle sprayheads at either side of a 338 x 220mm stainless steel bowl with 11/2" threaded male drain outlet and wall bracket. The nozzles give improved “wetting” and water “cling” to areas such as the eyes, nose, chin or cheeks. and have individual flow adjustment. The side mounted supply stem has a 1/2" NPTF stay-open ball valve activated by a trigger bar. Inlet connector 1/2” NPTF. Requires connection to a suitable water supply.
SB730-20 Eyewash SE505 Eye/Face Wash SE400
Wall mounting with three shrouded aerated sprayheads mounted at either side of a 465mm x 325mm stainless steel bowl with 11/2" threaded male drain outlet and wall bracket. Flow controls in each sprayhead ensure a consistent spray pattern whilst the shrouds create converging 'bands of water'. The sprayheads are supplied by an offset 1/2" NPTF, stay-open ball valve. The valve is activated by a large push plate. Inlet connector 1/2" NPTF. Requires connection to a suitable water supply.
SB740-10 Eye/Face wash SE400 Installation notes:
The drench hoses and eyewashes listed here are supplied ready to fit with inlet connectors for attachment to a suitable water supply. The user/installer must ensure that:
a) A potable water supply is used.
b) The units are securely mounted and permanently installed in an accessible and identifiable location.
c) All connection joint threads are sealed using PTFE plumbing tape. d) The supply pressure is adequate (minimum 20psi, maximum 125psi static). e) The units are periodically checked and tested (we suggest weekly). f) Fitting abbreviations:
NPT = U.S. National Pipe Thread NPS = U.S. National Pipe Standard –M = Male –F = Female