TRANSMISSION & DISTRIBUTION TECHNOLOGY
AGREENER GRID I
Francesco Ierullo discusses upgrading the grid to accommodate renewable energy
n its Renewable Energy Sources and Climate Change Mitigation report, the International Panel on Climate Change (IPCC) highlighted
that renewable energy has the capacity to displace greenhouse gas emissions from fossil fuel combustion, while simultaneously improving energy access. To use renewable energy to its full potential, electrical infrastructure must be updated to accommodate the increase in supply and transport power to where it’s needed. Using composites can improve renewable energy transmission across the grid. Despite eff orts to lower energy use, the rising population and economic growth are driving global energy demand. To balance global demand with clean energy use, we must invest in projects that enable increased use of energy from renewable resources. However, to accommodate a widespread use of renewables in infrastructure, the grid must be capable of meeting modern energy demands.
A CLOSER LOOK AT CONDUCTORS Renewable energy sources may be located far from where the generated energy is consumed. For example, the majority of wind power plants in Italy are based in the south of the country, but the nation’s industrial hub is located in the north. As a result, transmission and distribution infrastructure must be capable of carrying the additional load. Many of these power lines were installed decades ago and were not designed to accommodate the additional mix of modern energy sources. Traditional conductors consist of an outer aluminium conducting ring and a reinforcing steel core – known as aluminium conductor steel reinforced (ACSR) conductors. However, their current capacity is limited by the steel core that has a high coeffi cient of thermal expansion, meaning the heat from the current passing through the conductor and the ambient temperatures cause the steel to expand.
T e result is a lengthening of the conductor between the tower supports, which causes thermal sag, where the conductor drops lower to the ground. T is is exacerbated in older conductors that have a natural sag after being hung for decades. Sag that exceeds standards poses a safety risk and can lead to power outages, so these conductors must carry a lower current. Despite the issues of the old conductors in the grid, many utility companies are reluctant to perform a complete replacement of tower infrastructure as it requires a great amount of labour, time and economic investment. T is is particularly true in areas with uneven terrain, such as mountains where additional equipment such as helicopters may be required.
A COMPOSITE SOLUTION In place of a complete infrastructure replacement, ACSR lines can be upgraded to composite cored conductors, which have a lower coeffi cient of thermal expansion, allowing the conductor to carry over twice the amount of current. T e high strength- to-weight ratio of composites translates into a higher tensile strength, which allows the conductor to be pulled tighter. Composite cores are more lightweight than steel, allowing more conducting aluminium in the conductor and therefore increased transmission capacity. T e upgrade is signifi cantly cheaper than total grid replacement, as it can reuse the existing pylon and tower infrastructure. T e process is also substantially quicker, which minimises disruption
to energy supply. Additionally, if the composite-cored conductors are used in a new area where the electrical infrastructure must start from scratch, the high current capacity allows the tower count to be reduced. Exel Composites manufactures strong and lightweight composite cores with a low coeffi cient of thermal expansion. T e cores have performed strongly in accelerated ageing testing with minimal reduction in performance, and the company can work with utilities to respect their testing needs. Carbon fi bre composite cores are produced using cost-effi cient continuous manufacturing processes of pultrusion and pull-winding, and can be spooled kilometres at a time to keep production costs low, while ensuring consistent quality. Renewable energy will play a crucial role in mitigating climate change and provides the opportunity to improve energy supply. Upgrading older power lines from steel cored conductors to composite alternatives will increase the current capacity of the grid, transporting renewable energy effi ciently from generation to end use – helping to power the future.
Francesco Ierullo is with Excel Composites.
www.excelcomposites.com
Traditional conductors are limited by their steel cores
12
www.engineerlive.com
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36 |
Page 37 |
Page 38 |
Page 39 |
Page 40 |
Page 41 |
Page 42 |
Page 43 |
Page 44 |
Page 45 |
Page 46 |
Page 47 |
Page 48 |
Page 49 |
Page 50 |
Page 51 |
Page 52
