4 Gas Detection


SAFE TRANSPORTATION OF SOLID FUELS FOR POWER GENERATION GAS DETECTION FOR SHIPPING WOODCHIPS AND COAL


The modern maritime industry relies on gas and fl ame detection for safe operations. LNG, LPG, and refi ned products tankers carry thousands of tonnes or fl ammable, volatile hydrocarbons. Bulkers transport grains, cement, coal, and wood chips.


Whilst some of these commodities may at fi rst sight appear less harmful than a cargo of gasoline, coal and wood chips can spontaneously combust as they heat up in the presence of air. Some types of coal release methane during shipping. Wood chips can release carbon monoxide, a poisonous gas.


The hazards of bulk cargoes are not always obvious. It pays to review the best practices, codes and regulations for gas and fl ame detection.


Safety at sea


Gas detection can ensure that the risks associated with these hazards can be minimised.


Gas analysis in the cargo hold headspace can be achieved via gas sampling ports. This enables monitoring of the gas composition in the headspace without opening the hatch covers. Oxygen (O2


), methane (CH4 ), carbon monoxide (CO), carbon International codes and regulations


Gas detection is mandated in maritime applications. Guidelines, Codes, Regulations and Standards must be understood and implemented by ship designers, crews, and dock side teams.


Of general relevance is the SOLAS regulation XI-1/7 on Atmosphere Testing Instruments for Enclosed Space MSC.1/ Circ.1485 from January 2015. It states that ‘Every ship to which chapter I applies shall carry an appropriate portable atmosphere testing instrument or instruments’ and confi rms several additional details.


Cargo hold monitoring system Poisonous gases from wood chips


In 2002, during the discharge of pellets from MV WEAVER ARROW in the Port of Rotterdam, one dock worker died, and several others were injured after entering a hold where wood pellets had generated CO.


A similar case occurred in 2006 onboard the MS SAGA SPRAY in the Port of Helsingborg, Sweden while the vessel was discharging wood pellets from cargo hold number 9. One seaman was killed, a bulldozer driver was seriously injured, and eleven rescue workers were examined in hospital after entering an unventilated stairway next to a cargo hold. Carbon monoxide (CO) poisoning due to improper ventilation was found to be the cause of the incident. The CO had built up in the hold since the vessel had left port in Canada, less than three weeks before the incident.


Measurements that were taken by the Helsingborg Port Authorities on cargo holds 5 and 6 of MS SAGA SPRAY confi rmed that CO had built up to approximately 1,000ppm and the oxygen level had fallen to 15%.


The emission rate of carbon monoxide from wood pellets can be more than 500 mg CO per tonne of woodchips per day. Methanol, formic acid, and formaldehyde can also be released from wood chips.


Coal –the main solid bulk


fuel for power generation Coal is the second most heavily shipped bulk cargo, after iron ore. It is differentiated as steam coal or coking coal according to its quality. It can be shipped either as lumps or powder. The different types and sizes of coal present different hazards. For example, coal powder can liquefy and slosh around in the hold. Additionally, powdered coal may also spontaneously heat up and ignite. Some grades of coal release methane gas during shipping.


i. The instrument should be capable of remote sampling and detection for all gases that it is designed for, without interference from the atmosphere or other characteristics of the intervening space.


ii. Upon activation, the instrument should perform a ‘self-test’ which indicates that the instrument is functioning correctly.


iii. The instrument should be capable of measuring and displaying concentrations of the following gases prior to entry into enclosed spaces:


Cargo of wood chips dioxide (CO2 ) and hydrogen (H2 ) are gases that may need to be


monitored when transporting various bulk cargoes. Below are some examples of why certain gases are monitored and what their composition can indicate.


Oxygen is consumed by self-heating of coal or wood chips. If self-heating is occurring, the gas detection unit should show decreasing O2 CO2


levels. To mitigate the risk, an inert gas such as


or nitrogen can be used in the hold. Without oxygen being present, self-heating cannot occur in coal or wood chips.


Carbon monoxide is produced when self-heating or combustion occurs at low oxygen levels. CO binds to haemoglobin in the blood more strongly than oxygen thereby shutting down blood oxygen transport leading to CO poisoning.


Methane is released by some coals, so an increasing level indicates the coal is emitting CH4


. If the methane concentration


increases to 1% by volume, or 20% of the lower explosive limit (LEL), ventilation is required to reduce the risk of an explosion.


It should be noted that gas detectors that use the catalytic oxidation sensors cannot accurately measure methane or other fl ammable gases when the background oxygen level is less than around 12%. This is because the sensor relies on the reaction of the fl ammable gas with oxygen. To ensure an accurate reading, the measurement device may need to be aspirated with fresh air.


a. oxygen; b. fl ammable gases or vapours (% LFL); c. carbon monoxide; d. hydrogen sulphide.


iv. The instrument should clearly and unambiguously show which gas or vapour it is measuring.


v. If the instrument is fi tted with an alarm function, it should activate at the appropriate level.


vi. The instrument should be suitably protected, having due regard for the environment & temperatures in which it is expected to operate.


Potential hazards


IET NOVEMBER / DECEMBER 2023


Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32  |  Page 33  |  Page 34  |  Page 35  |  Page 36  |  Page 37  |  Page 38  |  Page 39  |  Page 40  |  Page 41  |  Page 42  |  Page 43  |  Page 44  |  Page 45  |  Page 46  |  Page 47  |  Page 48  |  Page 49  |  Page 50  |  Page 51  |  Page 52  |  Page 53  |  Page 54  |  Page 55  |  Page 56