Needing more fill to better balance the de- Moving to the opposite side of the bike, I This process is used on all remaining
sign I add some simple airbrushed effects go through the same process; however, I parts of the bike. Here is a picture of the
to create a completed image. flip the skull in order to create a mirror tank after all airbrushing described above
image of the graphic design. has been completed.
Once all airbrush graphics are finalized, I
peel off the tape on the lower half of all
parts making sure to leave the center
graphic covered which was laid out in the
previous issue.
Next, I back tape all parts. Shown here
are the gas tank and front fender. Back
taping consists of covering the area that
was previously worked on, which in this
case is the top half of each part that has
been edge faded and airbrushed.
Once back taping is complete, all parts
are moved into the paint booth and the
bottom graphic color is sprayed.
Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32