FEATURED TECHNOLOGY: SPONSORED CONTENT
KEEP IT
COHERENT O
ne of the biggest topics on the collective mind of the optical communications industry this year – no, not that one – has to be fiſth-
generation coherent optics. Tere has now been a raſt of trials and demonstrations, highlighting 800G wavelength achievements. As an example, Verizon completed a
successful test in its live fibre network to move 800Gb/s of data on a single wavelength across longer distances. A 800Gb/s single-wavelength transmission was accomplished over 667km between Nashville and Atlanta; and a 600Gb/s single-wavelength transmission over 2,283km from Atlanta to Memphis with a loop back in Memphis. As one might expect, this has prompted much
debate surrounding the performance of 800G wavelengths in real-life scenarios, at the heart of which is the ‘capacity versus optical reach’ trade- off. Te challenge, of course, with high-capacity optics, has been their limitation for longer-haul applications because they have relied on higher
32 FiBRE SYSTEMS n Issue 29 n Autumn 2020
Full capacity? When it comes to 800G coherent, Keely Portway considers how to address capacity-reach
order modulation, leaving the 200 to 400G wavelengths as the reserve of long-haul networks. In addition, all 800G generation coherent optical engines do not perform in exactly the same way.
Cost reductions Paul Momtahan, director of solutions marketing at Infinera, believes that wavelength capacity reach has a direct impact on the cost-per-bit. ‘If we can get 50 per cent more capacity at 600G, rather than 400G, for a particular reach requirement, it can reduce the cost-per-bit by a third. If we can get double the capacity, 800G rather than 400G, this halves the cost-per-bit.’ Other benefits of increasing capacity reach, said Momtahan, include reductions in space, power consumption and total cost of ownership. Momtahan went on to explain that he feels
there are three categories that impact the capacity-reach of high-capacity optics. Tese are ultra-high baud rates – which provide the key lever for increasing wavelength capacity-reach and enable the use of lower-order modulation
to achieve the same data rate; innovative features – such as Nyquist subcarriers and probabilistic constellation shaping (PCS); and a high modem signal-to-noise ratio (SNR). ‘We came out with these trials of 800G at
long-haul distances that blew away people’s expectations of what you could do with 800G,’ he explained. ‘We kept geting asked, “how are you doing it? What are the tricks up your sleeve?” And the answer is that it’s not one particular “trick”, it is all of these things in combination with each other.’ Take Modem SNR, for example, which
Momtahan acknowledged hasn’t previously been spoken about that much in the industry at a marketing level. ‘But, for example,’ he said, ‘if you crank an optical engine to 96GBd at 800G, you get a lot of noise generated inside the optical engine. So, this isn’t the noise that comes from outside the engine from the amplifiers or the fibre, that’s the noise inside the engine. Tat becomes a very critical factor, especially when you want very high data rates at 800G.’
www.fibre-systems.com @fibresystemsmag
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36 |
Page 37 |
Page 38 |
Page 39 |
Page 40 |
Page 41 |
Page 42 |
Page 43 |
Page 44 |
Page 45 |
Page 46