search.noResults

search.searching

dataCollection.invalidEmail
note.createNoteMessage

search.noResults

search.searching

orderForm.title

orderForm.productCode
orderForm.description
orderForm.quantity
orderForm.itemPrice
orderForm.price
orderForm.totalPrice
orderForm.deliveryDetails.billingAddress
orderForm.deliveryDetails.deliveryAddress
orderForm.noItems
ANALYSIS & OPINION: TEST & MEASUREMENT


LET’S GET PHYSICAL


WHY RAPID-LINK HEALTH VALIDATIONS ARE VITAL IN MULTIPLE DWELLING UNITS, AND HOW TECHNICIANS CAN IMPROVE EFFICIENCY


ROMAIN TURSI P


hysical connections inside homes are still the most efficient way to get the best bandwidth possible. Tis is true for detached, single-family homes


and multiple dwelling units (MDUs). Tis article discusses how technicians can improve efficiency, while performing installation and cabling activities, and how companies can consequently close more projects faster.


What’s an MDU? An MDU is a classification of housing where multiple separate residential housing units are in one building or several buildings in one complex, for example condos, rented apartments/flats etc. Figure 1 illustrates a typical fibre to the


premise (FTTP) infrastructure, where the construction job is terminated at a fibre distribution hub or network access terminal. Single-family homes are addressed one at a time (when a customer orders a service) with drop installation typically part of the activation phase. For MDUs, since operators are tasked with


reaching each customer in each living unit, installers need to visit each one and require access to pathways in walls and ceilings. Costs will add up if pathways must be reopened every time a new customer orders a service.


22 FiBRE SYSTEMS n Issue 29 n Autumn 2020


Tis is especially true for fire-sealed locations in MDU buildings. Consequently, the goal is for operators to install, ensure all is correct, check that fire seals are operational again and never reopen them.


What is an installer’s job? Technicians install feeder lines inside buildings, typically in the main telephone room (MTR) in the basement, also known as a telecom or electrical room. Tey set up patch panels with spliters and ports connected to the fibres going up to each unit. Spliter outputs are not connected but are ready for future service activation. Next, technicians install fibre going from


the basement up to inside each unit. Tey go through risers in conduits or outside walls to distribute fibre-per-floor before pulling them up into residential units. A point of entry can be on top of apartment doors and can be terminated with an optical outlet. At this stage, there is no optical network terminal (ONT) and all is dark fibre between the apartment and the MTR. Tis scenario considers a single spliter


basement – a simple infrastructure – but the infrastructure design could include cascaded spliters. On site, while conduits are open,


www.fibre-systems.com @fibresystemsmag


Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32  |  Page 33  |  Page 34  |  Page 35  |  Page 36  |  Page 37  |  Page 38  |  Page 39  |  Page 40  |  Page 41  |  Page 42  |  Page 43  |  Page 44  |  Page 45  |  Page 46