TECH INSIGHT: NON-DESTRUCTIVE TESTING


Enhancing laser-based ultrasound


for non-destructive testing A new technique provides a flexible and simple method for remote generation of ultrasonic surface waves


A


team of researchers has developed a non-contact laser-based method for


generating ultrasonic waves for non-destructive testing (NDT) and evaluation applications. The technique, described


in Applied Physics Letters in September, uses a patch consisting of candle soot and polydimethylsiloxane to amplify the signal of a photoacoustic laser source. Many industrial buildings, including nuclear power plants and chemical plants, rely on ultrasound instruments that monitor the structural integrity of their systems without damaging or altering their features. The researchers claim their


new approach marks one of the first NDT methods that combines elements of both contact and non-contact ultrasound testing.


Ultrasound waves can be


made by striking a surface with a high-powered laser. The heat produced by the pulses induces a pattern of expansion and compression on the illuminated area, yielding an ultrasonic signal. The waves produced, called Lamb waves, then travel through material as an elastic wave. In the researcher’s setup,


the surface being struck by the laser is a patch featuring a line array of candle soot nanoparticles and polydimethylsiloxane (see image). Candle soot was used because it is readily available and efficient at absorbing lasers, and can produce the elastic expansion needed to make the photoacoustic conversion that generates the Lamb waves. The line array configuration enables the bandwidth of the ultrasonic


waves to be narrowed, filtering out unwanted wave signals and increasing the analytical accuracy of NDT applications. The patch also enables the amplitude of the ultrasonic waves to be increased by more than two-fold, compared to conditions where the patch wasn’t used.


“The waves produced, called Lamb waves, then travel through material as an elastic wave”


‘Our laser-based NDT method


offers temperature-independent measurement and a wide range of monitoring area by easy changing of the position of the devices,’ said Taeyang Kim, an author on the Applied Physics Letters paper. ‘This technique provides a very flexible and simple method for the non-


contact and remote generation of ultrasonic surface waves.’ The researchers,


from North Carolina State University and the Korea Military Academy, still need to determine how durable their new approach is in an industrial setting, in addition to how well the patches perform on curved and rough surfaces. They also expect their new NDT approach to attract attention that will see others explore which materials could be used to optimise the patch, and which applications their approach can be used for. The team will be testing the


system in high-temperature NDT scenarios. The researchers have


applied for a patent for the new technology, which was developed with support from RMIT Seed Fund and Design Hub project grants. EO


Fabrication process of patterned candle soot (CS) nanoparticle (NP) polydimethylsiloxane (PDMS) patch


38 Electro Optics October 2019 @electrooptics | www.electrooptics.com


Taeyang Kim


Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32  |  Page 33  |  Page 34  |  Page 35  |  Page 36  |  Page 37  |  Page 38  |  Page 39  |  Page 40