PARTNERFOCUS
Don’t Ever Compromises on Power Supplies for ATEX Systems
“It’s more than just a logo on a datasheet” – says Marco van der Linden, UK Country Manager for PULS Power, here’s why?
to electronic controls, relays and contactors, for PoE communication systems or for motor drives. During the conversion from AC mains to lower DC power outputs, switch mode power supplies produce high voltages and currents that, if incorrectly designed, may cause sparks and may also generate excess heat through inefficient design topologies being used. Certification of equipment and protective systems for use in hazardous areas such as offshore installations have been in force for many years and there is a well-established supply chain for electrical equipment designed to meet the regulatory requirements. Preventing the creation of explosive atmospheres and eliminating sources of ignition are the two main ways of reducing risk. Ensuring the correct equipment is installed in the system can help greatly in this. In addition, there is a duty placed on employers (The Dangerous Substances and Explosive Atmospheres Regulations 2002) to eliminate or control the risks from explosive atmospheres in the workplace. Introduced in 2003, the ATEX Directive covers both electrical and mechanical equipment and is mandatory for any equipment to be used in hazardous areas throughout the EU. Electrical equipment requires independent certification for use in a Zone 1 area and most electrical equipment manufacturers also provide additional certification for Zone 2 products. Products from reputable manufacturers would be expected to be certified to both schemes.
D
How Does ATEX Apply to Power Supplies? To meet ATEX regulations, power supplies must be designed with larger creepage and clearance distances on the PCB than may be normal, this provides “over surface” and” through air” protection against conduction or sparks. Outputs must be protected from overload and overcurrent to prevent the possibility of damage to the
IN-Rail Power supplies are found in almost every industrial process control system. They may be required to provide power
32 SEPTEMBER 2021 | ELECTRONICS TODAY
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36 |
Page 37 |
Page 38 |
Page 39 |
Page 40 |
Page 41 |
Page 42 |
Page 43 |
Page 44 |
Page 45 |
Page 46 |
Page 47 |
Page 48 |
Page 49 |
Page 50 |
Page 51 |
Page 52 |
Page 53 |
Page 54 |
Page 55 |
Page 56 |
Page 57 |
Page 58
