Feature & Benefits


The system consists only of luminaires, each with acontroller and sensor. There are no remote sensors.


One Daylight sensor controls Daylight Groups


Occupied / Unoccupied mode Interface with Other Services


Automatic Recommissioning


•Zero on-cost for the installation of controls •A sensor in every luminaire ensures full presence coverage •Any component failure only affects the individual luminaire, not the whole zone


•Having one daylight sensor in a zone rather than one per luminaire ensures that lights dim in logical groups rather than randomly.


•When the building is occupied the lighting can be set for maximum comfort: Lights might dim but not switch off.


•The lighting sensors can be used to control other devices; Drinks machines, water heaters, heating and air extraction systems can be


switched off when the building is unoccupied.


•Any component, including sensors, DALI drivers and wireless nodes can be replaced without recommissioning. The new device will


inherit the settings of the device replaced.


luceco.com | 39


Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32  |  Page 33  |  Page 34  |  Page 35  |  Page 36  |  Page 37  |  Page 38  |  Page 39  |  Page 40