FLIGHT OF THE PHOENIX DOWN UNDER MY 2 CENTS
I am in awe of aviation mechanics. I have always admired their ability to fix complex and even not-so-complex machines by wading through (what are to me) confusing, thick, cumbersome maintenance manuals.
One of the most accomplished helicopter mechanics, or engineers as they’re called in Australia, who I ever had the pleasure of knowing was a 60-year-old Australian helicopter engineer by the name of Keith Angel. Keith became my first civilian boss after I left the U.S. military. He hired me to fly his brand-new Hughes 300 to herd cattle in the Northern Territory.
That old fox had an innate ability to fix anything, and I mean anything. I witnessed his uncanny mechanical aptitude when he purchased a Cherokee Six, sight unseen, that had run out of gas and crashed in the remote Simpson Desert, 72 miles south of the tiny Outback town of Bedourie, population 14. Under his tutelage, he and I set off to rebuild her where she crashed with the idea of flying her out, similar to the movie “Flight of the Phoenix.”
This adventure began in 1974 in the days before GPS, so we navigated using simple dead-reckoning skills: flying on time, distance, and heading while using a World Aeronautical Chart where one inch equaled 14 miles.
Fifty-five minutes out of Bedourie, where we’d refueled at a car gas station, Keith looked at the chart and said, “We’re getting close, mate.”
A glint suddenly caught my eye. Keith pointed, “Bloody hell, man, there she is!” The crippled green-and-white airplane came into view. I landed the chopper 30 yards from the aircraft.
Keith’s initial inspection revealed that she had a bent prop; both of the main landing gear were twisted, the engine basket holding the engine onto the airframe was bent, the nose gear was completely buckled under, and the left wing flap was ripped and torn.
Keith concluded, “We’ll have to do a run-out check on the engine to see if the crankshaft’s bent. If it is, we’ll have to dismantle her and fly the pieces to Bedourie, then truck the parts back to Brisbane and rebuild her there. But if the crankshaft isn’t bent, we’ll fly the damaged parts by chopper to Bedourie, truck in the replacement parts to Bedourie, then when they arrive we’ll fly the new parts here by chopper, install them, build an airstrip, then we’ll bring in a pilot to fly her out.”
We spent the remainder of the day in 120-degree heat disassembling the plane’s “bingled bits,” as Keith called them. After disconnecting the mechanical, electrical, fuel and oil connections to the engine, with a makeshift A-frame we lowered the engine onto a tarp. With the propeller removed and using a dial indicator, Keith got on his knees to perform a run-out check on the engine to determine if the crankshaft had been bent.
I stood over Keith anxious to hear his verdict. Without looking up he said with a wry tone, “You know, the sun’s rays have to travel 93 million miles and there’s always some bastard to block the last three feet.”
To our great relief the crankshaft hadn’t been bent in the crash. “We’ll fly her out from here!” Keith announced happily.
The following day, I made several 55-minute ferry flights to Bedourie carrying the broken parts, some underslung, that would be trucked to Brisbane for replacement.
When I flew back to the campsite on my last flight of the day, Keith had inhibited the engine’s cylinders, squirting oil into each one, then covered it up with a tarp awaiting our return when the new parts arrived.
Five weeks later, the new parts arrived at the Bedourie post office and I ferried them out to the crash site. Keith hired a pilot, Gary Doyle, to fly the plane out once we’d installed the new parts.
By Randy Mains
It took all three of us one full day to install the left and right main landing gear. Gary spent most of the time asking Keith nervously, “Do you really think this’ll work, Keith?”
“She’ll be right, mate, no worries.”
Keith noticed the skin on top of the left wing was rippled. He told Gary he was pretty sure the main wing spar wasn’t damaged but, unwilling to take any chances, he added five feet of angle iron to the underside of the left wing using pop rivets. This unnerved Gary no end. “Do you really think this’ll work, Keith?” he asked again.
“She’ll be right, mate, no worries.”
The second day we bolted the engine to the engine basket. Using an A-frame and block and tackle, we hoisted the whole works in a position, nose gear and all, where we could bolt the engine back onto the airframe.
Keith’s method for installing the tangle of disconnected electrical, mechanical, and oil lines was brilliant. With no maintenance manual we asked Keith, “Where do we attach all this stuff?”
He answered, “Just pull on the wire, linkage or hose until it won’t stretch any further, then look for a place to install it.” Gary and I were amazed that his method actually worked.
Gary noticed the firewall had been caved in, restricting the movement of the rudder pedals. “No worries,” Keith said. He climbed in and proceeded to bang the firewall back with a large ball-peen hammer.
Between bangs Gary again asked, “Are you sure this’ll work, Keith?”
Keith hollered back between bangs, “No worries, Gary.”
Keith filled the tanks with 35 gallons of fuel, and hooked up two 12-volt batteries, in series, to the external power plug on the airplane. Gary primed the engine, called out, “Clear!” and turned the key while
10 Sep/Oct 2022
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36 |
Page 37 |
Page 38 |
Page 39 |
Page 40 |
Page 41 |
Page 42 |
Page 43 |
Page 44 |
Page 45 |
Page 46 |
Page 47 |
Page 48 |
Page 49 |
Page 50 |
Page 51 |
Page 52 |
Page 53 |
Page 54 |
Page 55 |
Page 56 |
Page 57 |
Page 58 |
Page 59 |
Page 60 |
Page 61 |
Page 62 |
Page 63 |
Page 64 |
Page 65 |
Page 66 |
Page 67 |
Page 68 |
Page 69 |
Page 70 |
Page 71 |
Page 72 |
Page 73 |
Page 74 |
Page 75 |
Page 76 |
Page 77 |
Page 78 |
Page 79 |
Page 80 |
Page 81 |
Page 82 |
Page 83 |
Page 84
