8B-22 Air Bag System:
Step Action Yes No
2 1) With ignition switch OFF, disconnect SDM connector. Go to Step 4. Go to step 3.
2) Check proper connection to SDM at “L29-26” terminal.
3) If OK, turn ignition switch ON and then check voltage
between “L29-26” terminal on SDM connector and body
ground.
Special tool
(A): 09932-76010
(A)
"L29-26"
I4RS0A820100-
Is voltage 8 V or more?
3 1) With ignition switch OFF, disconnect on connector “L04” Go to Step 4. Check circuit from
junction block assembly. battery to “L04”
2) Check proper connection at “L04-1” terminal.
connector and charging
3) If OK, turn ignition switch ON and then check voltage
system.
between “L04-1” terminal and body ground.
"L04-1"
I4RS0A820012-
Is voltage 8 V or more?
4 1) With ignition switch OFF, reconnect SDM connector. Substitute a known- Check charging system
good SDM and recheck. and repair as necessary
With ignition switch ON, does DTC B1017 exist?
referring to “Generator
Test (Undercharged
Battery Check): in
Section 1J”.
NOTE:
Upon completion of inspection and repair work, perform the following items.
• Reconnect all air bag system components and ensure all components are properly mounted.
• Clear DTCs referring to “DTC Clearance: ”, if any.
• Repeat “Air Bag Diagnostic System Check: ” to confirm that the trouble has been corrected.