Sensor and Peripheral Compatibility Table


DEVICE


SENSORS Anemometers (cup or propeller) Anemometers (2-D sonic) Anemometers (3-D sonic) Barometers Ceilometers GPS


CR300-Series CR800/CR850 CR1000 CR6 Series


     


CR3000


CR9000X


    


       


Present Weather   Pyranometers   Reflectometers   Relative humidity   Shaft encoders   Strain gauges   Tipping buckets   Thermistors   Thermocouples  


Vibrating wire Visibility


COMMUNICATIONS PERIPHERALS MicroSD


CompactFlash® Ethernet


Direct Connect    


Multidrop Modems   PCMCIA Cards (type I, II, or III)


Phone Modems (cellular)   Phone Modems (land-line)


Radios (narrowband UHF/VHF)   Radios (spread spectrum/SRD860)   Satellite Transmitters (GOES)   Satellite Transmitters (Argos)   Satellite Transmitters (Iridium)   Short-Haul Modems  


MEASUREMENT AND CONTROL PERIPHERALS (see note 4) Multiplexers  


SDM Devices CDM Devices (see note 5)   Wind Vanes  


  see note 2         


   





    


  





       





   


       


  





see note 3 see note 3


see note 3


 


           


 


     


 


see note 3


 


Notes: 1. To determine compatibility with devices not offered by Campbell Scientific or devices not listed on this chart, refer to the device’s product brochure or manual, or contact Campbell Scientific.


2. Contact Campbell Scientific about configuration requirements for using the CR9000X with our GPS sensor. 3. Although compatible, phone modems, spread spectrum radios, and short haul modems do not support the CR9000X’s maximum communication rate. 4. Measurement and control devices typically used with the CR9000X are the AM25T multiplexer, SDM-CAN and SDM-INT8. Although compatible, the AM16/32B multiplexer, SDM-CD16AC, and SDM-CVO4 do not support the CR9000X’s maximum communication rate and are not practical for most CR9000X applications.


5. Our CR6-series dataloggers support CDMs natively through their CPI port. The CR800, CR850, CR1000, and CR3000 must use an SC-CPI interface.


Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32  |  Page 33  |  Page 34  |  Page 35  |  Page 36  |  Page 37  |  Page 38  |  Page 39  |  Page 40  |  Page 41  |  Page 42  |  Page 43  |  Page 44  |  Page 45  |  Page 46  |  Page 47  |  Page 48  |  Page 49  |  Page 50  |  Page 51  |  Page 52  |  Page 53  |  Page 54  |  Page 55  |  Page 56  |  Page 57  |  Page 58  |  Page 59  |  Page 60