search.noResults

search.searching

dataCollection.invalidEmail
note.createNoteMessage

search.noResults

search.searching

orderForm.title

orderForm.productCode
orderForm.description
orderForm.quantity
orderForm.itemPrice
orderForm.price
orderForm.totalPrice
orderForm.deliveryDetails.billingAddress
orderForm.deliveryDetails.deliveryAddress
orderForm.noItems
INSTRUMENTATION • ELECTRONICS


Choosing the right leak testing equipment is of vital importance


Testing W TECHNOLOGIES


How to choose a leak testing method that’s best for your needs


hen deciding on the best solution for a leak testing challenge, many factors need to be


taken into consideration, including the risk, suitability and cost of each method. Various technologies are available and it’s critical to choose one that is optimal to your application requirements. In recent years, huge strides have been made in electronic leak testing methods that use air or tracer gases, resulting in new techniques, enhanced sensitivity and faster test cycles. These changes have resulted primarily as


a response to cost pressures as well as the need to adapt to a changing environmental and safety regulatory environment. Before making any decision on


  it’s best to discuss your options with a professional equipment supplier to get  solution. Here, we look at two main


technologies, namely air leak testing  and helium leak testing (with mass 


AIR LEAK TESTING WITH MICRO-FLOW SENSOR In this method, the test part is pressurised from a pressure source with the regulator and valve isolating the test part from the source once pressurisation is complete. The pressure sensor then monitors and measures the pressurised test part and if the pressure measurement decreases, air is leaking out of the component or assembly under test. As air leaks, the micro  maintain a constant pressure, with the loss causing an electrical signal that is proportional to volumetric or mass


www.engineerlive.com 57


Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32  |  Page 33  |  Page 34  |  Page 35  |  Page 36  |  Page 37  |  Page 38  |  Page 39  |  Page 40  |  Page 41  |  Page 42  |  Page 43  |  Page 44  |  Page 45  |  Page 46  |  Page 47  |  Page 48  |  Page 49  |  Page 50  |  Page 51  |  Page 52  |  Page 53  |  Page 54  |  Page 55  |  Page 56  |  Page 57  |  Page 58  |  Page 59  |  Page 60  |  Page 61  |  Page 62  |  Page 63  |  Page 64  |  Page 65  |  Page 66  |  Page 67  |  Page 68