PRODUCTS & EQUIPMENT
The Polysoude TIGer - burning bright in the world of industry
The Polysoude TIGer Cladding System represents the next evolutionary stage in Hot Wire Technology.
n this unrivalled system, Polysoude has built on the main principle of Hot Wire Technology; this being the preheating of filler material, in order to reduce the quantity energy taken from the electrical arc, required to melt the filler, thereby assuring increased productivity of cladding speed and deposition rate.
I
The Technical Leap… With its remarkable properties, the TIGer system represents a leap forward in Hot Wire Technology! In addition to the pre-heated filler wire, TIGer incorporates a unique system of two tungsten electrodes in tandem configuration. This allows the ignition of two electrical arcs, which, by way of mutual
Fig.1: Compact TIGer Cladding Cell (courtesy of Polysoude)
attraction, combine to convey a single heat source. This single heat source has a lower arc
Fig.3: TWIN-TIGer torch (courtesy of Polysoude)
pressure than in classic tandem configurations, yet it is capable of reaching much higher cladding
speeds and deposition rates than the standard TIG/GMAW HW process.
Fig.2: 5G horizontal cladding rig (courtesy of Polysoude) IMT December 2015/January 2016
18
www.internationalmetaltube.com
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32