This page contains a Flash digital edition of a book.
BPC Metalwork Brochure Galvanised Heavy Duty Joist Hangers


Joist Hanger Type D (Straddle) Top Flange Up To 250mm


The straddle type joist hanger is used when timber joist positions are directly opposite each other on either side of a wall or beam. As standard the straddle hanger is manufactured to suit 100mm blockwork , however any width is available to order.


Width 38mm, 44mm, 47mm, 50mm, 63mm, 75mm, 100mm, 125mm, 150mm


Depth 100mm 125mm 150mm* 175mm* 200mm* 225mm* 250mm*


Bearing surface 75mm Order Code = SPMH/D/width x depth(block size) i.e. SPMH/D/50x200(100)


Special Masonry Hangers


Special masonry hangers can be manufactured to suit applications where unusually heavy loads occur. Available in galvanised or stainless steel heavy gauge plate, to customer drawings.


A range of Stainless Steel timber to masonry hangers are available to order.


*Please note: As standard all hangers 150mm deep and above are manufactured 10mm less to allow for regularised timber and to ensure that joist levels are maintained.


4 Tel 01924 364 794


Please specify the type of hanger required together with the following dimensions :


a.Width b. Depth c. Length of top flange on Type R and Type D only. Type S top flange is 75mm.


© BPC 2011/12


Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32