44
nanotimes News in Brief Batteries //
New Nanostructure for Batteries Keeps Going and Going © Based on Material by Stanford University
improving lithium-based batteries: a cleverly de- signed double-walled nanostructure that lasts more than 6,000 cycles, far more than needed by electric vehicles or mobile electronics.
A
“This is a very exciting development toward our goal of creating smaller, lighter and longer-lasting batte- ries than are available today,” Cui said. Lithium-ion batteries are widely used to power devices from electric vehicles to portable electronics because they can store a relatively large amount of energy in a relatively lightweight package. The battery works by controlling the flow of lithium ions through a fluid electrolyte between its two terminals, called the an- ode and cathode.
The promise – and peril – of using silicon as the anode in these batteries comes from the way the lithium ions bond with the anode during the char- ging cycle. Up to four lithium ions bind to each of the atoms in a silicon anode – compared to just one for every six carbon atoms in today’s graphite anode – which allows it to store much more charge. Howe- ver, it also swells the anode to as much as four times its initial volume. What’s more, some of the electro- lyte reacts with the silicon, coating it and inhibiting further charging. When lithium flows out of the anode during discharge, the anode shrinks back to its original size and the coating cracks, exposing fresh
The new double-walled silicon nanotube anode is made by a clever four-step process: Polymer nanofi- bers (green) are made, then heated (with, and then without, air) until they are reduced to carbon (black). Silicon (light blue) is coated over the outside of the carbon fibers. Finally, heating in air drives off the carbon and creates the tube as well as the clamping oxide layer (red). © both images:Hui Wu, Stanford, and Yi Cui
silicon to the electrolyte. Within just a few cycles, the strain of expansion and contraction, combined with the electrolyte attack, destroys the anode through a process called “decrepitation.”
Over the past five years, Cui’s group has progres- sively improved the durability of silicon anodes by making them out of nanowires and then hollow silicon nanoparticles. His latest design consists of a double-walled silicon nanotube coated with a thin layer of silicon oxide, a very tough ceramic ma-
terial.This strong outer layer keeps the outside wall of the nanotube from expanding, so it stays intact.
team led by materials scientist Yi Cui of Stanford University and SLAC has found a solution for
12-04 :: April/May 2012
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36 |
Page 37 |
Page 38 |
Page 39 |
Page 40 |
Page 41 |
Page 42 |
Page 43 |
Page 44 |
Page 45 |
Page 46 |
Page 47 |
Page 48 |
Page 49 |
Page 50 |
Page 51 |
Page 52 |
Page 53 |
Page 54 |
Page 55 |
Page 56 |
Page 57 |
Page 58 |
Page 59 |
Page 60 |
Page 61 |
Page 62 |
Page 63 |
Page 64 |
Page 65 |
Page 66 |
Page 67 |
Page 68 |
Page 69 |
Page 70 |
Page 71 |
Page 72 |
Page 73 |
Page 74 |
Page 75 |
Page 76 |
Page 77 |
Page 78 |
Page 79 |
Page 80 |
Page 81 |
Page 82 |
Page 83 |
Page 84 |
Page 85