Instrumentation
Checking of thermocouple and platinum resistance thermometer (Pt100) sensors
W
hen temperature sensors must be routinely checked and/or calibrated in accordance with in-house quality
procedures or other, national standards, there are various ways of achieving such compliance. These typically involve sending the sensors to an accredited laboratory for certification, an expensive and time consuming procedure.
A practical, highly cost effective alternative method is to use an in-house, temperature calibration system from Labfacility; this provides a rapid and simple method of sensor checking and traceable calibration ‘on the bench’. This comprises a thermal reference (dry block)
calibrator, a UKAS certified reference thermometer (Pt100), a calibrated L200 8 channel indicator/ logger and PC software: this, when used with any Windows PC represents a complete solution for on-site accreditation which allows direct comparison of the thermocouple or Pt100 probes (up to seven at a time) with the UKAS certified reference sensor. A simple calculation of difference temperature (if any) between the logged values indicated by the reference and each test probe at a given, stable temperature (chosen by the user) in the dry block calibrator gives the error
value for each sensor at particular temperatures. The procedure can be repeated for alternative temperatures set on the dry block as required (eg 70, 100, 125, 150˚C).
The system can even be used independently
of a PC if desired; rather than working with logged data, readings for each probe can be taken manually by means of the L200 front panel key and differences calculated by the user. This is an equally valid procedure. The accuracy of a type T, Class 1
thermocouple for example, is similar to that of a Pt100 Class B; nominally ±0.5˚C and ±0.3˚C respectively at 0˚C. A Class A Pt100 will provide an order greater accuracy however. Measurement uncertainty with such a system
will be of the order of ±0.6oC for both types of sensor at 250˚C. ■
Enter 43 or ✔ at
www.engineerlive.com/epe
Labfacility Ltd is based in Bognor Regis, West Sussex, UK.
www.labfacility.co.uk
Circle 43A or ✔ at
www.engineerlive.com/epe
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36 |
Page 37 |
Page 38 |
Page 39 |
Page 40 |
Page 41 |
Page 42 |
Page 43 |
Page 44 |
Page 45 |
Page 46 |
Page 47 |
Page 48 |
Page 49 |
Page 50