FEATURE Sensors & Sensing Systems
Inductive sensors in mobile cranes ensure tucked-in legs
Contrinex two-wire inductive sensors ensure safe operation of mobile cranes with maintenance-free interlocks
Before the system will allow the driver to drive the vehicle away, sensors confirm that the stabiliser legs have been retracted
A
manufacturer of mobile cranes uses Contrinex two-wire inductive sensors (see image below) to detect the position of stabiliser legs as part of the vehicle safety system. Before the system will allow the driver to drive the vehicle away, sensors confirm that the
stabiliser legs have been retracted (see image above right).
CUSTOMER APPLICATION Mobile cranes, telescopic handlers and the like are equipped with extendable stabiliser legs to prevent them from tipping over when lifting. These stabiliser legs (or jacks) are mechanical extensions of the chassis which widen the base of the vehicle’s chassis to ensure its stability in all operating situations. However, when the time comes to move the vehicle, there must be verification that these stabilisers are fully retracted. Either an indicator in the driver’s cabin or a method of disabling engagement of the vehicle’s transmission is used to ensure safety and prevent drive-away accidents and damage.
The customer’s existing verification system relies on mechanical contacts. However, the costs of maintenance and replacements over the long lifetime of such vehicles are relatively high and hence a non-contact solution was sought.
SOLUTION A normally-closed, two-wire inductive sensor from Contrinex’s Classic 600 Series was ideal for this application. Multiple sensors – one for each stabiliser cylinder – are installed and
14 July/August 2021 Irish Manufacturing
connected in a way that requires each sensor to be satisfied that a target is either present or absent, thus completing a logic circuit. Initially, the simplest approach would seem to be to wire this group of devices in series, as would be the case with mechanical contacts. However, when using sensors, series wiring presents the challenge of voltage drops. The customer overcomes this by selecting two-wire sensors with a normally-closed output, then wiring them in parallel to create a logical NAND setup. This wiring solution resolves the issue and permits an easy-to-implement, non- contact, non-mechanical approach to providing feedback for the warning or inhibiting mechanism of the vehicle. PLUS Automation can help address a wide-range of applications, improve machine performance and reliability, and reduce costs using Contrinex’s exceptional inductive, photoelectric, ultrasonic, RFID and machine-safety sensors.
PRODUCT ADVANTAGES INCLUDE: • No readjustment over time; • No wear and tear and relatively tamper- proof;
• Long-term reliability; • No maintenance;w • Easy adjustment/setup; • Local annunciation (LED indicator).
Contrinex
www.contrinex.com Plus Automation Ltd.
www.plusax.co.uk
www.irish-manufacturing.com
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36 |
Page 37 |
Page 38 |
Page 39 |
Page 40 |
Page 41 |
Page 42 |
Page 43 |
Page 44
