TECHNICAL | SUSTAINABLE TUNNELING
in Rome to London, that represents at the very least an extra 32.5 metric tonnes of CO2 produced per day of
operation.” (The figures are calculated via
roadnet.com Carbon Emissions Calculator). There is more. Harding goes on to consider comparisons between
TBM-bored tunnels and those constructed through tunneling methods, such as drill and blast. “Mechanically excavated tunnels result in smoother
tunnel walls and a 40 to 90 percent reduction in installed ground support. The smoother cross section results in less excavated material that must be hauled out of the tunnel, and mechanized tunneling eliminates the risk of nitrous run off and plastic waste that are present in material from drill and blast.”
RE-USE PERSPECTIVE FOR CONTRACTORS On that basis, then, using a reconditioned TBM can deliver significant carbon savings on a tunnel project. Contractors will be reluctant to use them, though,
if there may be a downside of reduced reliability and tunneling progress rates; meters excavated per day is the almost-universal measure of a project that is progressing well and profitably, and a TBM breakdown can be an absolute disaster. How confident can contractors be about using what a
used-car salesman might call a pre-loved TBM? Harding offers some figures. “In terms of meters per day, more than one third –
36% to be precise – of currently standing world records have been broken using a refurbished TBM; some of those machines had been in service for decades before setting their records.” Key to that, of course, is wear and tear on the machine
in its earlier usages. Some parts can be refurbished between projects, some can be replaced altogether, some are harder to change; the cost savings – and the embodied energy and emissions savings – will depend on the extent of rebuilding required. This will be highly variable, says Harding, but generally the simpler the project, in terms of geology and special conditions, the greater the savings. “They can range from 75% cheaper for simple
Top right: 20” disc cutter assembly Top & Center: Main Beam TBM was built in 1980 for a subway job in New York and most recently was refurbished and modified for DigIndy project tunnels in Indianapolis Bottom: Inspection and maintenance are vital
16 | Summer 2023
machine with a project with tested ground conditions to 20% cheaper for a project with complex requirements, such as high pressure EPB.” But, generally speaking, there is no real limit to the
number of projects that a TBM can be used on, nor on the number of kilometers an individual machine can bore, he says.
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36 |
Page 37 |
Page 38 |
Page 39 |
Page 40 |
Page 41 |
Page 42 |
Page 43 |
Page 44 |
Page 45 |
Page 46 |
Page 47 |
Page 48 |
Page 49 |
Page 50 |
Page 51 |
Page 52 |
Page 53 |
Page 54 |
Page 55 |
Page 56 |
Page 57
