


The system consists only of luminaires, each with acontroller and sensor. There are no remote sensors.


One Daylight sensor controls 


Occupied / Unoccupied mode Interface with Other Services


Automatic Recommissioning


• Zero on-cost for the installation of controls • A sensor in every luminaire ensures full presence coverage • Any component failure only affects the individual luminaire, not the whole zone


• Having one daylight sensor in a zone rather than one per luminaire ensures that lights dim in logical groups rather than randomly.


• When the building is occupied the lighting can be set for maximum comfort: Lights might dim but not switch off.


• The lighting sensors can be used to control other devices; Drinks machines, water heaters, heating and air extraction systems can be


switched off when the building is unoccupied.


• Any component, including sensors, DALI drivers and wireless nodes can be replaced without recommissioning. The new device will


inherit the settings of the device replaced.


luceco.com | 25


Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28