1. The base Cut 4 sticks to the same length and thickness. Tape the corners together to make a square.
2. The frame
Decide what height you would like your lantern and cut 4 sticks the same length. Tape the ends onto the base corners, and fix them all together at the top with tape.
3. Make a loop To make a carrying loop, bend a piece of wilow and attach with tape to the top. You can also attach a bamboo cane to this if you want a longer handle.
The messy bit Put a sheet of tissue paper on your tray and using a brush or a sponge, cover it with diluted PVA glue (50:50 works best). Holding the four corners apart, place it on the lantern structure. Cover the whole lantern, but remember to leave a gap at the bottom to insert the light. Overlap the edges of the paper as you go, smoothing any bits that stick out.
4. Shine a light Once your lantern is dry, insert your LED and light it up! You can also paint your lantern or use different coloured tissue paper to decorate.
Photo: Steve Tanner
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32
