PORTABLE SOLUTIONS


ONSITE ADVANTAGES W


orker safety, weld quality, and productivity rightly come to mind when welding


onsite or on large structures. In these environments, it is typical for the operator to work closely with a rugged, compact and lightweight wire feeder, connected to a weather-resistant power source hundreds of feet away. Until now, portable wire feeders have


been available in two configurations: basic ‘across-the-arc’ models or portable feeders equipped with an added control cable. ‘Across-the-arc’ models are powered by


the weld cable. This configuration provides the benefit of fewer cables running back to the power source, but voltage control at the point of use is not possible. The addition of a control cable to the


system allows the operator to adjust voltage at the point of use, but these


22 / WELDING WORLD MAGAZINE - ISSUE 01 - JANUARY 2025


cables can be costly and add additional complexity to the production environment. Lincoln Electric says there is


now a better way with the addition of its CrossLinc Technology.


Output Control at the Arc CrossLinc feeders enable voltage control at the feeder without the extra cable. The result is greater productivity, safety, and quality. Avoid the negative aspects


Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32  |  Page 33  |  Page 34  |  Page 35  |  Page 36  |  Page 37  |  Page 38  |  Page 39  |  Page 40