This content requires Adobe Flash Player version
or later.
Either you do not have Adobe Flash Player installed,
or your version is too old,
or there is a problem with your Flash installation and we were unable to detect it.
MARS Motor Protector solve the problem of finding suitable replacements for motor overloads protectors. These overloads will replace most standard overloads on 1/20th thru 1/2 HP at 115V and 1/12th thru 1 HP at 230V. Used in refrigeration, room air condi- tioners, refrigerators, freezers and motors. Each overload has 6" leads and two wire nuts for simple installation.
Intended for use as a starting assist for PSC air conditioning com- pressors. This kit utilizes a positive temperature coefficient solid state material which when wired in parallel with the run capacitor of a PSC motor, provides additional starting torque. PTC device re- quires a 3 minute cool-down period before recycling and therefore cannot be used on a system wired for capacitor off-cycle crankcase heat.
CAT. NO. MFG. NO. EACH 6Z8900
3 Terminal $100.50
1013 PG
HARD START DEVICES
With OEM approval for permanent installation. Approved by Du- cane, Goodman and York to replace original equipment manufac- turers start kits. For single phase 208v to 265v A/C, refrigeration and heat pump compressors. Kickstart® hard start devices utilize a start capacitor/potential relay combination to allow air conditioning and heat pump compressors to start with maximum efficiency thus reaching normal rated speed at up to 10 times faster than compres- sors without hard start device installed.
CAT. NO. MFG. NO. USE WITH: EACH 8G8911 8G8912
MPR5 MPR1
8G8911A 1 to 3 HP 3.5 to 5 HP TO-5 (2 PC) 1 to 3 HP 8G8912A KS1 (2 PC) 3.5 to 5 HP
$75.12 $67.14 $57.35 $82.15
HEAT PUMP DEFROST TIMER
Electro-mechanical defrost timer for time initiated/ time or temperature terminated applications. Provides 10 minute defrost periods at 45 or 90 minute select- able intervals; 2-SPST switches, 240v AC operation. Exact replacement for General Electric and Paragon controls used as original equipment on Carrier, Bryant and Trane heat pumps.