5 Manufacture and Fabrication


to move in conjunction with the existing gutter as well as coping with normal thermal and building movement.


The system has a complete range of accessory components and techniques which are able to cope with any existing gutter conditions or circumstances including an expansion and contraction joint which may be used to allow Unifold®


Every effort is expended to factory fabricate Unifold®


to its most complete form possible prior to shipment leaving site operatives the simplest of tasks to install the system fully.


Sole Board


in order to provide a flat level surface for the lining system and to allow for bolt and stud intrusions in the existing gutter.


A sole board is usually required beneath Unifold®


The minimum thickness required is 10mm which allows for bolt heads, however, thicker boards will be required to allow for stud intrusions if these are not to be removed.


If thicker boards are to be used consideration should be given to gutter capacities.


Installation Unifold®


is installed with the absolute minimum


of disruption to processes beneath by fully trained professional contractors, who together with Ampteam, provide a partnership to ensure that every Unifold®


solution is of the highest quality in every respect.


Sole boards are usually insulation board and Extruded Polystyrene is recommended, however, bitumen impregnated Fibre Board is acceptable.


The UNIFOLD® Solution


01384 252777 Phone us


unifold@ampteam.co.uk Click on email


www.gutterliners.com Click on website


UNIFOLD® gutter lining system Manufacture and Fabrication


Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28