“Clip on” temperature controllers with mounting clamp suitable for vessels with wall thickness up to 25mm. All models incorporate a splash-proof case, coiled immersion heater and pressure circulating pump (except TU-20HT). In addition they are fitted with an adjustable overtemperature cut-out and conform to international standards for radio frequency interference.
TE10D, TU20D and TU20-HT models have a low liquid level cut-out.
TU-20D and TU20-HT have a built-in RS232 interface which allows them to communicate with the users’ personal computer if required using Thermsoft PC control freeware available from www.techne.com.
All 230V units are supplied with both UK and European Schuko plugged mains supply leads.
Tempunit® Ltd.
is a registered trade marks of Techne Tempunit® Range
Stability (DIN 58966) Pump capacity
Overall L x W x H Model TE-10D Digital
Versatile controller for accurate repeatability of temperature settings.
–40 to +120°C* ±0.01°C
10 litres/minute 237 x 124 x 260mm
For 230V 50/60Hz single phase supplies. BJ765-25 TE-10D Digital
Tempunit® Model TU-20D Digital
High precision, digital controller with wide temperature range and fine temperature adjustment. Fitted with bi-directional RS232 interface for programming by a personal computer.
Range
Stability (DIN 58966) Pump capacity
Overall L x W x H
–40 to +200°C* ±0.005°C
10 litres/minute 237 x 124 x 260mm
For 230V 50/60Hz single phase supplies. BJ770-25 TU-20D Digital
* Accessory cooling is required for operation near or below ambient temperature.
Dip coolers – see BJ925 series.
Polypropylene spheres to minimise evaporation – see BJ177-03.
Tanks with bridge mounting plates for use with controllers – see BJ816/BJ819. Refrigerated Circulator Baths – see CL160/CL162.
Tempunit® Model TU-20HT Digital
Ultra-wide ranging, high accuracy, digital controller with adjustable over-temperature cut-out and alarm, bi-directional RS232 interface and fitted cooling coil.
Range
Stability (DIN 58966) Overall L x W x H
–40 to +250°C*† ±0.005°C
237 x 124 x 260mm
For 230V 50/60Hz single phase supplies. BJ775-30 TU-20HT
Notes: * Accessory cooling is required for operation near or below ambient temperature. †TU-20HT does not have an external circulation facility, and for use above 200˚C, a Techne liquid calibration bath tank must be used.
Accessories
Cooling coil for all models. Requires a supply of cold water. BJ778-06 Cooling coil
BJ770-25, BJ765-25 and BJ775-30 are similar & +44 (0)20 7729 2405 e-mail: export@ajcope.co.uk fax orders: +44 (0)20 7729 2657
