This page contains a Flash digital edition of a book.
Too Early To Think About Cutworms?


secticides for cut- worms. No-till and late burndown appli- cations that allow weeds to persist in the field are factors


I’


that increase the chances of cutworm infestations. It is best to maintain a clean seedbed for at least two and


DR. SCOTT STEWART JACKSON, TENN.


ve had a couple of calls related to the use of in-


preferably three weeks prior to planting. This will go a long way in eliminating the chances of cutworm problems, but it is sometimes easier said than done. A relatively low rate of a


pyrethroid insecticide is com- monly suggested to prevent cut- worm damage. However, I do not recommend including an insecticide with herbicide ap- plications that are made more than two weeks in advance of planting. Tank mixing an in- secticide with an early burndown ap- plication does not make much sense. Cutworms you kill would have proba- bly ‘cycled out’ be- fore you planted anyhow. And be- cause you cannot expect much residual control, there is the pos- sibility of reinfestation between application and planting. The best time to make this application is just before or at plant- ing (or within a day or two after planting). A few other points for


your consideration: • No insecticide seed treatments should be ex-


pected to provide substantial control of cutworms. • Although Bt corn and cotton


traits provide some protection against cutworms, planting into fields that are heavily infested is a risky business. Herculex, VT3 Pro, VT2 Pro and SmartStax corn can re- duce cutworm injury, and I would ex- pect the same from the Viptera technology.


In cotton, WideStrike


will suppress cutworm injury better than Bollgard II. However, large lar- vae are much less susceptible to Bt


DR. SCOTT STEWART: IPM Exten-


sion Specialist, University of Ten- nessee


toxins. So, if populations are high enough, I suspect any Bt technology can be overwhelmed. • Ammo 2.5 EC and its generic


equivalents (e.g., Up-Cyde) are not labeled for use in corn or soybean.


equivalents (e.g., Arctic) are not la- beled for use in cotton.


• Pounce 3.2 EC and its generic ∆


Agri-Equipment Inc.


Ford 1210 w/Woods mower ʻ71 IH 656 Farmall tractor


TRACTORS


ʻ11 6088 combine 224 sep. hrs., warranty w/3020 head


ʻ11 7120 combine warranty, 274 sep. hrs. w/35ʼ draper


COMBINES & PLATFORMS


ʻ10 7120 combine 675 hrs. w/35ʼ draper, good


ʻ93 1688 3600 hrs., Mudhog, shedded


2208 c. head w/adapter Used header trailer ʻ94 1688 4050 hrs., Mudhog, chopper ......... ..........................$30,000


7088 combine 650 hrs., sharp


3408 cornhead, 2500 acres


ʻ98 2388 shedded, new augers, bushings, chopper, field tracker


1020 25ʼ header 1020 30ʼ header, oil bath


Union City, Tennessee • 731-885-1440 USED EQUIPMENT


JD 6F 1350-1450 in the farrow plow, veri-width 14-18”


2- Soybean drills w/hitch 44ʼ JD960 field cult. w/5ʼ peg tooth harrow..$9,500


Bushhog 3 pt. blade, w/hydraulics, 8ʼ


30ʼ JD960 field cult. w/3 bar harrow ..............$4,000


IH 983 cornhead v. good ..... ................................$6,500 ʻ04 2388 duals, 1478 hrs., yield & moisture FIELD EQUIPMENT


490 disk, 25ʼ w/22” blades, exc.


30ʼ JD235 disc, 9” spacing 20” blades


12 row 900 cyclo air planter, vert. fold...$4,000


1020 25ʼ flex header, wet wobble box, good


ʻ95 CIH955 16 row frt. fold, new D.D. openers and closing disk PLANTERS


ʻ04 1200 16/31 Pivot planter Pro600 nice planter ʻ08 1240 16/31 Pivot planter Pro 600


ʻ07 1200 16/31 Pivot planter 4,000 acres, Pro 600 monitor, shedded


Agri-Equipment, Inc. Union City, Tennessee • 731-885-1440


©2005 CNH America LLC. All rights reserved. Case IH is a registered trademark of CNH America LLC. CNH Capital is a trademark of CNH America LLC. www.caseih.com


8• MidAmerica Farmer Grower / February 24, 2012 Licensed to Drill Ag Wells in KY MO & TN


www.irrigationcentral.com 573-472-0886


Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32