Hammer time!
Clegg hammers are now being widely used in top level sport to measure surface condition
THE Clegg Impact Soil Tester (commonly referred to as a clegg hammer) is a sophisticated, but simple to use, means for measuring and controlling soil strength and consolidation levels during pitch maintenance. It is also used to confirm uniform compaction over wide areas of ground, identifying poorly compacted areas and ineffective rolling of materials.
There are four sizes available. These include
0.5kg and 2.25kg types suitable for sportsturfs, with an optional special golf course tester for fairways. The larger 10kg and 20kg testers are used for testing harder materials and roadworks. The tool consists of a compaction hammer operating within a vertical guide tube. When the hammer is released from a fixed height it falls through the tube and strikes the surface under test, decelerating at a rate determined by the stiffness of the material within the region of impact. A precision accelerometer mounted on the hammer feeds its output to a hand held digital readout unit which registers the deceleration in units of Impact Value. It provides a compact and reliable instrument
for monitoring and controlling the quality of reinstatements while the work is in progress, avoiding the need for re-excavation if later tests were to indicate poor workmanship. In order to obtain a reliable reading of impact
value it is necessary to carry out five test drops at each location. The following procedure should be followed, regardless of the material
being tested:
1. Choose a test position where the guide tube can stand upright without assistance. If necessary remove excessive loose surface material (scuffing with the side of the shoe or boot is usually adequate) and ensure that the tube is not standing over a stone larger than any other stones visible at the surface.
2. Check that the guide tube is reasonably vertical and steady. Remove the locking pin that retains the hammer inside the tube and unclip the meter unit. Press the button on the readout and check the display shows zero IV (impact value).
3. Raise the hammer with one hand until the white indicator ring is level with the top of the guide tube. Make sure the cable is free and will not snag as the hammer falls; then drop the hammer cleanly. Observe the meter reading.
4. Without moving the guide tube or releasing the readout button, repeat the procedure for a further four drops to give a total of five readings at the test position.
5. Assess the set of five readings. The first two or three drops effectively take up the surface irregularities and loose material immediately beneath the hammer. The readings thereafter should get progressively higher. The third, fourth and fifth readings should level out and register the stiffness of the compacted layer under test.
The fourth reading is the critical reading; it
represents the degree of compaction being measured. If any of the readings is more than 2 IV lower than a previous reading, or if the fifth reading is greater than the fourth by more than 2 IV, then the measurements are generally not reliable and the test should be abandoned at that location. A repeat test should be carried out around 300mm away from the position of the abandoned test location. The clegg hammer is now widely used in
sport, particularly at the top end. It is used at Wimbledon to help set up the courts, whilst the physiotherapist at Leicester City FC measures both the home and away pitches to establish if there is any correlation between the hardness of a pitch and player injuries.
The condition and hardness of a pitch will be
influenced by many factors. One with little or no effective maintenance will become compacted, resulting in poor sward composition and poor drainage. The weather can also influence the condition of the pitch. So, by using the clegg hammer it is possible
to monitor pitch hardness and treat accordingly.
www.sdinstrumentation.freeserve.co.uk
Problems?
Shelton has low cost techniques to drain established greens, fairways and football pitches
DRAIN TODAY - PLAY TOMORROW
SOIL PENETRANT Problems with drainage
PERVADE
and waterlogged playing surfaces?
Spray PERVADE and your playing surface will get dryer
Phone: 01507 578288 Fax: 01507 578790
e-mail:
info@sheltonsdrainage.com www.sheltonsdrainage.com
Machine sales Hire and contracting services ASL
AGRONOMIC Services Ltd
David Snowden at Agronomic Services
Tel: 01765 658021 Mobile: 07799 036996 Email:
dpsfpg@aol.com
87
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36 |
Page 37 |
Page 38 |
Page 39 |
Page 40 |
Page 41 |
Page 42 |
Page 43 |
Page 44 |
Page 45 |
Page 46 |
Page 47 |
Page 48 |
Page 49 |
Page 50 |
Page 51 |
Page 52 |
Page 53 |
Page 54 |
Page 55 |
Page 56 |
Page 57 |
Page 58 |
Page 59 |
Page 60 |
Page 61 |
Page 62 |
Page 63 |
Page 64 |
Page 65 |
Page 66 |
Page 67 |
Page 68 |
Page 69 |
Page 70 |
Page 71 |
Page 72 |
Page 73 |
Page 74 |
Page 75 |
Page 76 |
Page 77 |
Page 78 |
Page 79 |
Page 80 |
Page 81 |
Page 82 |
Page 83 |
Page 84 |
Page 85 |
Page 86 |
Page 87 |
Page 88 |
Page 89 |
Page 90 |
Page 91 |
Page 92 |
Page 93 |
Page 94 |
Page 95 |
Page 96 |
Page 97 |
Page 98 |
Page 99 |
Page 100 |
Page 101 |
Page 102 |
Page 103 |
Page 104 |
Page 105 |
Page 106 |
Page 107 |
Page 108 |
Page 109 |
Page 110 |
Page 111 |
Page 112 |
Page 113 |
Page 114 |
Page 115 |
Page 116 |
Page 117 |
Page 118 |
Page 119 |
Page 120 |
Page 121 |
Page 122 |
Page 123 |
Page 124 |
Page 125 |
Page 126 |
Page 127 |
Page 128 |
Page 129 |
Page 130 |
Page 131 |
Page 132