ATEX EQUIPMENT
A
TEX is the EU standard for equipment used in explosive atmospheres, while IECEx is the global standard, and both certifications use the same Zone classifications. Introducing Zone 2 and Zone 22 servo motors enables end users and OEMs to meet key requirements for hazardous locations without specifying more costly Zone 1 and Zone 0 servo motors when their increased protection may not be necessary.
ACHIEVING NEW STANDARDS
Meeting Zone 2 classification means the motor can safely operate where flammable gases or vapours may appear briefly under abnormal conditions. The Kollmorgen AKME Series servo motor is designed to prevent sparks, hot surfaces, or failures that could ignite gas. The servo motor can also operate in environments where combustible
SERVO MOTORS FOR ATEX AND IECEX ZONE 2/22 HAZARDOUS LOCATIONS
Kollmorgen has released a new servo motor for use in hazardous locations including ATEX and IECEX certifications for Zones 2 and 22. Distributed in the UK by INMOCO, the new Kollmorgen AKME Series servo motors are based on the proven performance of Kollmorgen’s existing AKM servo motors. Delivering high torque density, responsiveness, and precision for applications that may be exposed to ignitable gases or dusts, the new AKME servo motors are available in a wide range of voltage ratings and feedback options.
dust may be occasionally present, signified by meeting Zone 22 requirements. The motor will prevent dust ignition, including via enclosure or surface temperature limits.
By meeting ATEX and IECEx Zone 2 and Zone 22 certifications, the AKME servo motors can be used in applications across pharmaceutical production, food processing, grain elevators, industrial paint booths, and other settings where combustible gases or dusts may be encountered. Achieving further protection for operation within harsh environments, the motors also meet IP64 protection, meaning they are dust-tight and prevent moisture ingress.
BROAD INSTALLATION POTENTIAL
Designed for continuous torque applications, the
24 SPRING/SUMMER 2026 | INDUSTRIAL COMPLIANCE
AKME servo motors can generate between 0.37 Nm to 50.4 Nm, operating at speeds up to 5,000 rpm. The motors are available in IEC frame sizes two to seven, spanning 54 mm to 188 mm, and can be powered by voltages including 48 and 75 Vdc, and 120, 240 or 400 Vac.
The AKME servo motors also support a wide range of feedback options with single- and dual-connector devices, including resolver, SFD-M, ComCoder, EnDat, Hiperface and BiSS B options. In control, the motors are ideally matched with Kollmorgen’s AKD, AKD2G, or Kollmorgen Essentials servo drives, and this combination operates with standard Kollmorgen servo motor cables that extend between 1 metre and 25 metres in length.
INMOCO is a motion control specialist distributor in the UK, providing motion engineering support in specification and application design. INMOCO can supply Kollmorgen’s new AKME Series servo motors along with servo motor cables and the full range of Kollmorgen servo drives, as a complete, matched package.
INMOCO
www.inmoco.co.uk
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36
