PC-MAR23-PG39.1_Layout 1 06/03/2023 12:21 Page 39
WATER & WASTE TREATMENT MIXER UPGRADE OPTIMISES THE BIOGAS PROCESS
A farm in the north west of Kent has enhanced its biogas operation by using Landia mixers to upgrade the mixing system on its two anaerobic digesters
O
ncoland Farm (part of The Billings Group) had been experiencing problems with the mixers that were installed when the gas-to-grid AD plant was built in 2020. Traditionally, a mixed farm of arable, dairy and beef, Oncoland has added hops, vines and renewable energy to its portfolio as part of its drive towards Net Zero. However, as Plant Manager, Carl Woolley discovered, the mixers that were included as part of the package deal, were unsuitable for the feedstock that combines the farm’s cattle slurry with waste from vegetables grown at the 2500-acre site, such as cabbage, potatoes and carrots. The feedstock also includes waste mango and pomegranate that is first sent though a hammer mill.
“The mixers would have probably been fine for a standard mix or maize and slurry,” said Woolley, “but for a plant such as ours with varying types of waste, you need much sturdier equipment. Only six months in to us producing biogas, we started to see that the submersible mixers were beginning to fail due to the ingress of water. Although the separate, paddle mixers in the digesters continued to do their job, over time, the submersible mixers,
one-by-one, gave up the ghost.”
Working closely with James Gorridge at Mid- Kent Electrical Engineering (MKE), Woolley looked at how best to resolve the issue with the submersible mixers and get the plant to its optimum operation.
“We weighed up the costs of retrieving the faulty mixers for repair and rewinding,” said James Gorridge, “but we both knew how disruptive that would be to the whole process, and the fact that we’d be fixing equipment that was inevitably going to fail again in only a short period of time.”
Woolley added: “Removing the submersible mixers would have first involved waiting for dry, calm weather and hiring in a crane. Then, two full days of arduous work and a huge amount of downtime in halting the biogas process, emptying the digesters, and then starting everything up again. We both went away to consider the best, long-term solution. MKE have always supplied us with very good quality motors and drives, with a very good turnaround and attention to detail, so I knew they believed in quality. During my career I’d seen just how robust mixers and pumps are from Landia. And based on his separate previous experience with Landia equipment, James agreed that despite the higher capital investment, their mixers would actually work out to be far more cost-effective and reliable in the long term, significantly reducing our maintenance costs.”
Woolley and MKE found that the original mixers had been underspecified, so chose to go up a mixer size to optimise the process. “We knew this would further improve the mixing, which is crucial for any biogas plant,” said Gorridge. “It would also have less impact on the new mixers from Landia, which would only have to run for 20 minutes per hour (compared to 24/7 for the failed mixers), saving considerably on energy consumption.” Four of Landia’s POP-I (18.5kW 300rpm) mixers were installed (two on each digester), with an
immediate positive effect on the process, which typically handles dry solids of around 8% and higher.
“Previously,” said Woolley, “it took time for everything in the tanks to get going, but the new Landia mixers resuspended the contents almost immediately. We now get comprehensive mixing and no crust whatsoever. The other important benefit is that the mixers are easy to maintain, especially with their twin-mechanical seals.” In addition to the two primary digesters, Oncoland’s pre-treatment tank (70m3
) has
benefitted from an upgrade to a Landia Chopper Pump.
“We took the opportunity to widen our upgrade to the pre-treatment tank,” said Woolley. “Again, the submersible mixer that was supplied as part of the plant package wasn’t up to the job, leaving lumps in the feedstock and dead spots in the tank. But now with the Landia Chopper Pump (11kW), which is extremely reliable, the feedstock of slurry from our dairy unit, plus the vegetable and fruit waste, is constantly conditioned so that our process benefits from a consistent soup. The Chopper Pump’s blades remain fine and sharp.”
He added: “With both the Landia pump and mixers, we now have peace of mind. Working with James at MKE, we saw that we could have bought mixers at around £4K less per unit, but biogas feedstocks are unforgiving. The whole process is about learning and nurturing. There’s just no hiding place for equipment that isn’t sturdy. We bought on reputation and can see already what a sound investment it has been. Biogas is a different beast here in the UK, so best buy the mixers and pumps that are fit for purpose.”
Landia
www.landiaworld.com Mid-Kent Electrical Engineering
www.mke.co.uk
MARCH 2023 | PROCESS & CONTROL 39
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36 |
Page 37 |
Page 38 |
Page 39 |
Page 40 |
Page 41 |
Page 42 |
Page 43 |
Page 44 |
Page 45 |
Page 46 |
Page 47 |
Page 48 |
Page 49 |
Page 50 |
Page 51 |
Page 52 |
Page 53 |
Page 54 |
Page 55 |
Page 56 |
Page 57 |
Page 58 |
Page 59 |
Page 60 |
Page 61 |
Page 62
