ABOUT JETLOC
Bonding Fasteners were originally designed to provide a strong load-spreading anchor in plastic, GRP and laminated products, but
have found a host of other uses where conventional fasteners cannot meet the requirements. They can be bonded into the
substrate or alternatively can be surface-mounted to most materials by means of adhesives or mechanical fasteners such as
screws, rivets or nails.
Each part consists of a Stud or Female Thread welded to a perforated Base Plate.
There are 4 basic standard Thread/Stud Forms: (shown here welded to a typical Base Plate)
Male Threaded Stud Female Hex Nut Female Threaded Collar Male Plain Stud
M4 - M10
M4 - M8 M4 - M10
∅ 4.75
Other diameters to special order
These are combined with any one of the following Base Plates:
23mm Round 38mm Round 38 x 15mm Rectangular
Other base plates available are: 19mm Round, 32mm Round, 50mm Round, 76mm Round, 15mm Square, 30mm Square, 50mm
Square, 38 x 19 Rectangular, 38 x 76 Rectangular.
Base Plates with female threads can be manufactured either open or closed to suit the application. Male plain stud types can be
used with various types of Push-on Fasteners.
The following ranges show the most popular combinations but, subject to minimum order quantities, we can supply any variation
and length of stud and the base plates above, including the thread/stud mounted horizontally onto the base plate. If you require a
combination that is not included in the following ranges please contact our Sales Office.
All types are Mild Steel, plated in Zinc and Yellow Passivate as standard. 316 Stainless Steel is also available to special order.
Thread Protectors, Plain Nuts, Wing Nuts and Washers are also available.
BONDING FASTENERS
www.jetloc.com
Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6