Saw Chain Maintenance


How to Tension your Saw Chain without Intenz® (cont.)


5. With either type of guide bar, hold the nose up and tighten your chain saw’s rear guide bar mounting nut first, then tighten the front nut.


6. Pull the saw chain by hand along the top of the guide bar several times, from the engine to the guide bar’s tip. Saw chain should feel snug but still pull freely.


Note: If you have a sprocket-nose guide bar you should now perform the snap test. Grasp the saw chain along the bottom of the guide bar, pull down, and let go. Saw chain should snap back to its original position, solidly contacting the bottom of the guide bar.


7. Check tension often during operation, especially during the first half-hour. If saw chain loosens: stop, let your chain saw cool, and readjust tension.


36


SAW CHAIN


Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32  |  Page 33  |  Page 34  |  Page 35  |  Page 36  |  Page 37  |  Page 38  |  Page 39  |  Page 40  |  Page 41  |  Page 42  |  Page 43  |  Page 44  |  Page 45  |  Page 46  |  Page 47  |  Page 48  |  Page 49  |  Page 50  |  Page 51  |  Page 52  |  Page 53  |  Page 54  |  Page 55  |  Page 56  |  Page 57  |  Page 58  |  Page 59  |  Page 60  |  Page 61  |  Page 62  |  Page 63  |  Page 64  |  Page 65  |  Page 66  |  Page 67  |  Page 68  |  Page 69  |  Page 70  |  Page 71  |  Page 72  |  Page 73  |  Page 74  |  Page 75  |  Page 76  |  Page 77  |  Page 78  |  Page 79  |  Page 80