This page contains a Flash digital edition of a book.
POUROVER


Steep walled canyons make accessing some runs a challenge. Down climbing often seems easier but when done properly, rap- pelling makes canyon access much safer. Kayakers don’t usually carry heavy


climbing gear so we have to do our best with a limited set of tools. Master these four basic components to a rappel and you’ll be tackling runs otherwise left behind.


Anchors Sturdy trees make great anchors. Tie a seg- ment of nylon webbing around the base of the tree using a water knot and clip on a locking carabiner. Wrapping the rope direct- ly around the tree can damage both the tree and the rope. If a tree isn’t available, artificial anchors such as nuts or pitons also work, though these require more expertise to set securely. Always place two or more artificial anchors to provide adequate protection.


RAPPELLING


MASTER THE DRY LAND SNEAK THE SLING HARNESS


1. Step into a 1.5-meter sling with both legs. Pull the sling to knee level and to the right.


1.


2. Twist the sling and step through the new loop with your right leg.


2.


3. Twist the new loop again.


4. Step through this loop with your left leg.


3.


5. Pull up to your waist and secure the two leg loops and the waist loop with a locking biner.


Rope Think about rappelling when selecting a throw rope. Only rappel off throw ropes with a Spectra core because it’s the stron- gest option. Spectra has a low melting point so rappel slowly or wet the rope be- forehand to help dissipate heat from fric- tion. Getting adequate rope length may require tying two throw ropes together us- ing a double fisherman’s knot. To ensure the rope doesn’t get caught, untie it from the bag. Feed the rope through the locking carabiner that is attached to your anchor. On more popular runs, secure a fixed line.


Rappel Devices A harness can be improvised with a long sling. To control your descent, attach a fric- tion device to a locking biner affixed to your harness’ belay loops. A figure eight or ATC are common mechanical friction devices. If you’re rappelling on a single throw rope or fixed line, a Munter hitch can also be used, requiring one less piece of hardware.


Rappeller To descend in control, face the wall with feet shoulder-width apart and lean back slowly, keeping the rope taut, until your legs are perpendicular


to the slope. The


breaking hand controls the speed the rope travels through the friction device and must always remain on the rope.


4.


Boats should be lowered separately unless you are descending straight into the water. In this case, secure the kayak to a cowtail attached to a quick release belt on the your PFD. Be prepared for the extra weight to pull you off balance. Another option that’s easier on the rappeller but takes a little lon- ger is to tie the boat directly into the rope. When paddling with a large group, keep


in mind that rappelling is fairly slow and creates bottlenecks. For more information refer to the latest edition of The Mountain- eers Books’ Freedom of the Hills. —Maximilian Kniewasser


5. 24 RAPID EARLY SUMMER 2011


PHOTOS: MAXIMILIAN KNIEWASSER


Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32  |  Page 33  |  Page 34  |  Page 35  |  Page 36  |  Page 37  |  Page 38  |  Page 39  |  Page 40  |  Page 41  |  Page 42  |  Page 43  |  Page 44  |  Page 45  |  Page 46  |  Page 47  |  Page 48