ASK THE EXPERT Home and dry
Andrew Scanlon of Everbuild answers some of the basement waterproofing queries asked by self- builders to help them avoid getting out of their depth in their projects
B
asement conversions have long been a popular way to increase the usable space in a home, used for
everything from living rooms and home offices, to kitchens and even bedrooms. Although different projects will require different approaches, one important factor to consider is how you are going to protect your new subterranean space from possible water damage and the associated problems of mould and dampness. Here are some answers to some of the key questions.
DO ALL BASEMENTS NEED TO BE
WATERPROOFED? It’s important to remember that by their very nature, basements are built below the ground and are at risk of water ingress and becoming damp. The most common source of water in basements is seepage from the groundwater held in the soil around the foundations of your home, although other factors such as pipes and a high water table can put some projects at a greater risk than
others. That’s why it’s important to seek expert advice before you start work to get a better idea of what you are dealing with. For the majority of projects though, choosing a high-performance waterproofing treatment can provide all the protection you need.
WHAT IS THE DIFFERENCE BETWEEN
TANKING AND WATERPROOFING? Waterproofing covers lots of different methods such as cavity drainage systems, but the term ‘tanking’ is most commonly used when referring to basement or cellar conversions. The tanking process involves applying a special waterproofing ‘slurry’ coating to prevent exterior water from penetrating the walls and floors. It’s important that the whole room is treated, not just the area where there is existing evidence of water damage as this will not stop the problem – water will enter the fabric of a building any way – and anywhere – it can, unless every possible route is sealed off. Tanking is an effective way of preventing water
ingress into a property as, as the term suggests, it can create an impenetrable, watertight barrier.
HOW DOES IT WORK? Tanking slurry prevents water droplets from seeping through the walls and floors into the basement by forming insoluble crystals which water can’t pass through. There are many different tanking products available on the market, but the best ones are those that offer flexibility and long-lasting protection. Flexibility is important as it needs to be able to cope with both negative and positive water pressure to act as a vapour permeable layer which will still allow the substrate to ‘breathe’ while preventing water from being able to seep through.
DO I HAVE TO DO ANY PREPARATION?
As with any building work, preparation is one of the most important parts of the job. Before you apply any waterproofing coatings, you should ensure that the surface is clean and free of any flaking paint, dirt or debris. It’s also important that any cracks or holes are filled prior to treatment as these will otherwise become weak spots. These can be treated with a suitable waterproof compound. The point where the floor and wall meet also needs special attention. Here, it’s recommended that you create a triangular ‘fillet’ at the intersection and seal it using a special durable plugging compound which will expand as it cures to form a permanent watertight seal with similar characteristics to concrete.
APPLICATION It’s a good idea to choose a product that can be brush or spray applied so you can quickly and easily coat larger areas, and one that can be applied to areas that are already damp. It’s important to cover the area thoroughly, so look for a product that is available in a choice of colours, (usually grey and white). Using different colours for each coat will make it easier to see any parts that have been missed, helping make sure you have applied the coating evenly across the whole area.
WHAT ABOUT DECORATIVE
FINISHES? If you’re looking to save time and money, choose a product that can be used as a final decorative finish too. If you’re planning on using render or plaster over tanking slurry, it’s essential to refer to the
6
www.sbhonline.co.uk jan/feb 2022
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36 |
Page 37 |
Page 38 |
Page 39 |
Page 40 |
Page 41 |
Page 42 |
Page 43 |
Page 44 |
Page 45 |
Page 46 |
Page 47 |
Page 48 |
Page 49 |
Page 50 |
Page 51 |
Page 52 |
Page 53 |
Page 54 |
Page 55 |
Page 56 |
Page 57 |
Page 58 |
Page 59 |
Page 60 |
Page 61 |
Page 62 |
Page 63 |
Page 64 |
Page 65 |
Page 66 |
Page 67 |
Page 68
