CULTIVATION TIPS ADVISIE Colder weather is coming
By Jos Hilkens AdVisie ‘the mushroom growing consultants’, Herkenbosch
hilkens@mushroomconsulting.nl
Now is the season to pay closer attention to steering the number of pins. Every year pinning occurs too spontaneously leading to excessive numbers of mushrooms on the beds. The result is a higher share of fine grade mushrooms, a lower picking performance and, depending on the prices achieved by fine and medium grades, lower financial returns. In many countries, the higher price for fine grades fails to compensate for the extra costs of harvesting. Closely monitor the number of mushrooms. Too many pins often form on the beds, so remain alert during pinhead development. Increasing the maximum CO₂ content from 400 to 600 ppm at night during cold nights and chilly weather generally does no harm and makes it easier to steer the RH without resorting to extreme corrections using spray booms, fogging systems or steam humidification. In autumn and early winter, compost quality is often lower with greater variations in extent of fermentation, structure and moisture content. It’s important that growers anticipate this by, for example, ordering lighter structure casing, adding sufficient CAC-material to heavy casing, reducing the volume of water applied during the preparatory phase and possibly delaying the first watering session. If the compost temperature after filling is below 20°C, allow the temperature to rise first before applying water. Sciarids remain a problem on some farms. Now is the ideal time to get rid of them altogether. If you fail to control these pests, you will suffer from continuous re-infections on your farm. Check the rubber seals around the large and small doors to the growing rooms. The joints between walls and floors are often a weak spot where sciarids can hide or travel from room to room via the work corridor.
Preventing watery stipe
By Jos Hilkens AdVisie ‘the mushroom growing consultants’, Herkenbosch
hilkens@mushroomconsulting.nl
As the name suggests, watery stipe indicates the stem has become waterlogged. The stem often looks glassy or translucent and is a greyish yellow when cut. This affects the appearance of the mushrooms and reduces the shelf life. Watery stipe typically occurs in the last two harvest days of the first flush with manual harvesting and with mechanical harvesting in the last 48 hours before the flush is cut. If not enough mushrooms for the final picking day are left on the beds, the mycelium directs all the water into just a few mushrooms. This causes moisture to build up in the stems. This problem is often greater with active compost. To prevent and control watery stipe regulate the compost temperature in the 1st flush to 23-24°C rather than 25-27°C. Ensure you can still pick 3-4 kg of mushrooms per m2 on the final harvest day and increase evaporation by raising the air temperature, lowering the RH and increasing circulation. With mechanical harvesting, the interval between the last watering session and harvesting is important, as well as the compost temperature and the degree of evaporation, similar to with manual picking. When harvesting mechanically, the timing of the harvest is crucial in steering the flush. Consequently, the air temperature in the growing room can vary widely from 14 to 22°C. If growth is slowed using a low air temperature, evaporation will stagnate and water is more likely to accumulate in the stems.
(advert)
6 MUSHROOM BUSINESS
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36 |
Page 37 |
Page 38 |
Page 39 |
Page 40 |
Page 41 |
Page 42 |
Page 43 |
Page 44 |
Page 45 |
Page 46 |
Page 47 |
Page 48 |
Page 49 |
Page 50 |
Page 51 |
Page 52 |
Page 53 |
Page 54 |
Page 55 |
Page 56